Linkage Kit Manual V6-00 - Fujitsu

More documents

Recommendations

Info

CHAPTER 5 SPECIFICATIONS OF A LINKER 5.2.4 Setting Entry Addresses and Symbol Values Section 5.2.4 describes those linker functions that set entry addresses and symbol values. ■ Specifying an Entry Address Use this function to set an address at which to start executing the program in an output load module. ■ Setting an External Symbol Value An error occurs if an external symbol is not defined after linking because of an incomplete program or an incorrect external symbol name. Use this function to set a temporary value to temporarily remove this error and create a load module executable for the time being. 58 PART II LINKER
5.3 Types of Sections 5.3 Types of Sections The minimum unit that a linker can combine is a section. Depending on the purpose of using sections in a program, they are located and combined differently. Section 5.3 describes section names, contents types, location attributes, and combination attributes. ■ Section Name A section name is used to identify a section. ■ Types of Section Contents Depending on the purpose of usage, there are the following five types of section contents: An assembler determines the attributes of execution, read, or write. Table 5.3-1 shows the section types. Table 5.3-1 Section Types Type Description Attribute CODE Program code area Executable, Read DATA Variable area Read, Write CONST Area of variable with initial value Read STACK Stack area Read, Write IO I/O area Read, Write ■ Section Location Attribute There are two section location attributes representing whether or not the section is relocatable. Table 5.3-2 shows the section location attributes. Table 5.3-2 Section Location attributes Attribute Description ABS REL Section in which absolute addresses are specified Relocatable section ■ Section Combination Attribute There are two section combination attributes representing whether the section is shared or combined. Table 5.3-3 shows the section combination attributes. Table 5.3-3 Section Combination attributes PUBLIC Attribute COMMON Description Sections are combined in succession. Sections are combined and overlapped at the same address. PART II LINKER 59
Page 1:
FUJITSU MICROELECTRONICS CONTROLLER
Page 5 and 6:
PREFACE ■ Objectives and Intended
Page 7 and 8:
CONTENTS PART I LINKAGE KIT .......
Page 9 and 10:
6.2.7 Specification to fill ROM are
Page 11 and 12:
CHAPTER 10 OPTIONS OF A LIBRARIAN .
Page 13:
APPENDIX ..........................
Page 16 and 17:
2 PART I LINKAGE KIT
Page 18 and 19:
CHAPTER 1 SPECIFICATIONS OF LINKAGE
Page 20 and 21:
CHAPTER 1 SPECIFICATIONS OF LINKAGE
Page 22 and 23: CHAPTER 1 SPECIFICATIONS OF LINKAGE
Page 36 and 37: CHAPTER 2 OPTIONS 2.1 Option An opt
Page 38 and 39: CHAPTER 2 OPTIONS 2.3 Notes and Eva
Page 40 and 41: CHAPTER 2 OPTIONS 2.5 Example of Sp
Page 42 and 43: CHAPTER 3 COMMON OPTIONS 3.1 List o
Page 44 and 45: CHAPTER 3 COMMON OPTIONS 3.2.1 Spec
Page 46 and 47: CHAPTER 3 COMMON OPTIONS For exampl
Page 54 and 55: CHAPTER 3 COMMON OPTIONS 40 PART I
Page 56 and 57: CHAPTER 4 OPTION FILES 4.1 Outline
Page 58 and 59: CHAPTER 4 OPTION FILES 4.3 Specifyi
Page 60 and 61: CHAPTER 4 OPTION FILES 4.5 Default
Page 62 and 63: CHAPTER 4 OPTION FILES 48 PART I LI
Page 64 and 65: 50 PART II LINKER
Page 66 and 67: CHAPTER 5 SPECIFICATIONS OF A LINKE
Page 106 and 107: CHAPTER 6 LINKER OPTIONS 6.1 List o
Page 108 and 109: CHAPTER 6 LINKER OPTIONS Table 6.1-
Page 110 and 111: CHAPTER 6 LINKER OPTIONS 6.2.1 Outp
Page 112 and 113: CHAPTER 6 LINKER OPTIONS 6.2.3 Debu
Page 114 and 115: CHAPTER 6 LINKER OPTIONS 6.2.5 Spec
Page 120 and 121: CHAPTER 6 LINKER OPTIONS 6.2.10 Map
Page 122 and 123:
CHAPTER 6 LINKER OPTIONS 6.2.12 Can
Page 124 and 125:
CHAPTER 6 LINKER OPTIONS 6.2.14 Dis
Page 126 and 127:
CHAPTER 6 LINKER OPTIONS 6.2.16 Spe
Page 128 and 129:
CHAPTER 6 LINKER OPTIONS 6.2.18 Che
Page 130 and 131:
CHAPTER 6 LINKER OPTIONS [Example 2
Page 132 and 133:
CHAPTER 6 LINKER OPTIONS [Example 5
Page 134 and 135:
CHAPTER 6 LINKER OPTIONS 6.2.20 ROM
Page 136 and 137:
CHAPTER 6 LINKER OPTIONS 6.2.22 Sec
Page 138 and 139:
Page 140 and 141:
CHAPTER 6 LINKER OPTIONS 6.2.25 Aut
Page 142 and 143:
CHAPTER 6 LINKER OPTIONS 6.2.26 Ret
Page 144 and 145:
CHAPTER 6 LINKER OPTIONS 6.2.28 Lib
Page 146 and 147:
Page 148 and 149:
CHAPTER 6 LINKER OPTIONS 6.2.32 Dum
Page 150 and 151:
Page 152 and 153:
CHAPTER 6 LINKER OPTIONS • When -
Page 154 and 155:
CHAPTER 6 LINKER OPTIONS 6.2.37 Fun
Page 156 and 157:
CHAPTER 6 LINKER OPTIONS 6.2.39 Use
Page 158 and 159:
CHAPTER 6 LINKER OPTIONS 6.2.40 Use
Page 160 and 161:
CHAPTER 6 LINKER OPTIONS Section ty
Page 162 and 163:
Page 164 and 165:
CHAPTER 6 LINKER OPTIONS 6.2.44 Sup
Page 166 and 167:
Page 168 and 169:
Page 170 and 171:
Page 172 and 173:
Page 174 and 175:
Page 176 and 177:
Page 178 and 179:
Page 180 and 181:
Page 182 and 183:
Page 184 and 185:
CHAPTER 6 LINKER OPTIONS 170 PART I
Page 186 and 187:
CHAPTER 7 OUTPUT LIST FILE OF THE L
Page 188 and 189:
Page 190 and 191:
Page 192 and 193:
Page 194 and 195:
Page 196 and 197:
Page 198 and 199:
Page 200 and 201:
Page 202 and 203:
Page 204 and 205:
Page 206 and 207:
Page 208 and 209:
Page 210 and 211:
Page 212 and 213:
Page 214 and 215:
CHAPTER 8 LINKER RESTRICTIONS AND Q
Page 216 and 217:
CHAPTER 8 LINKER RESTRICTIONS AND Q
Page 218 and 219:
204 PART III LIBRARIAN
Page 220 and 221:
CHAPTER 9 SPECIFICATIONS OF A LIBRA
Page 222 and 223:
Page 224 and 225:
Page 226 and 227:
Page 228 and 229:
Page 230 and 231:
Page 232 and 233:
Page 234 and 235:
CHAPTER 10 OPTIONS OF A LIBRARIAN 1
Page 236 and 237:
Page 238 and 239:
Page 240 and 241:
Page 242 and 243:
Page 244 and 245:
Page 246 and 247:
Page 248 and 249:
Page 250 and 251:
Page 252 and 253:
Page 254 and 255:
CHAPTER 10 OPTIONS OF A LIBRARIAN [
Page 256 and 257:
CHAPTER 11 LIST FORMATS OF A LIBRAR
Page 258 and 259:
Page 260 and 261:
Page 262 and 263:
CHAPTER 12 RESTRICTIONS AND QUESTIO
Page 264 and 265:
Page 266 and 267:
252 PART IV OBJECT FORMAT CONVERTER
Page 268 and 269:
CHAPTER 13 SPECIFICATIONS OF AN OBJ
Page 270 and 271:
Page 272 and 273:
Page 274 and 275:
CHAPTER 14 COMMON OPTIONS OF AN OBJ
Page 276 and 277:
Page 278 and 279:
Page 280 and 281:
CHAPTER 15 LOAD MODULE CONVERTER (f
Page 282 and 283:
Page 284 and 285:
Page 286 and 287:
Page 288 and 289:
Page 290 and 291:
Page 292 and 293:
Page 294 and 295:
CHAPTER 16 FORMAT ADJUSTER (m2ms, h
Page 296 and 297:
Page 298 and 299:
Page 300 and 301:
Page 302 and 303:
Page 304 and 305:
Page 306 and 307:
CHAPTER 17 BINARY CONVERTER (m2bs,
Page 308 and 309:
Page 310 and 311:
Page 312 and 313:
Page 314 and 315:
Page 316 and 317:
CHAPTER 18 OTHER CONVERTERS 18.1 m2
Page 318 and 319:
CHAPTER 18 OTHER CONVERTERS 18.3 i2
Page 320 and 321:
CHAPTER 18 OTHER CONVERTERS 306 PAR
Page 322 and 323:
Page 324 and 325:
Page 326 and 327:
APPENDIX APPENDIX A ERROR MESSAGES
Page 328 and 329:
APPENDIX ■ Error Messages of the
Page 330 and 331:
APPENDIX W1303L Section with initia
Page 332 and 333:
APPENDIX W1325L Entry point already
Page 334 and 335:
APPENDIX W1372L The section is plac
Page 336 and 337:
APPENDIX E4329L Value out of range
Page 338 and 339:
APPENDIX E4362L DUMMY section speci
Page 340 and 341:
APPENDIX F9001L Insufficient memory
Page 342 and 343:
APPENDIX F9026L Specified value out
Page 344 and 345:
APPENDIX F9053L Missing '-ro’ or
Page 346 and 347:
APPENDIX I0401U Reference to undefi
Page 348 and 349:
APPENDIX W1406U Module not exists t
Page 350 and 351:
APPENDIX E4470U CPU information fil
Page 352 and 353:
APPENDIX F9033U Illegal file format
Page 354 and 355:
APPENDIX ■ Error Messages of the
Page 356 and 357:
APPENDIX F9023U Illegal option para
Page 358 and 359:
APPENDIX F9049U Output range exceed
Page 360 and 361:
APPENDIX B.1 Common Format The HEX
Page 362 and 363:
APPENDIX B.2 Data Record (HEX8/HEX1
Page 364 and 365:
APPENDIX B.4 Extended Segment Addre
Page 366 and 367:
APPENDIX B.6 Extended Linear Addres
Page 368 and 369:
APPENDIX APPENDIX C S RECORD FORMAT
Page 370 and 371:
APPENDIX C.2 S1 Type (Data Record:
Page 372 and 373:
APPENDIX C.4 S3 Type (Data Record:
Page 374 and 375:
APPENDIX C.6 S7 Type (Terminator Re
Page 376 and 377:
APPENDIX C.8 S9 Type (Terminator Re
Page 378 and 379:
APPENDIX Table D-1 List of Linker O
Page 380 and 381:
APPENDIX APPENDIX E LIST OF LIBRARI
Page 382 and 383:
APPENDIX ■ List of options of the
Page 384 and 385:
APPENDIX 370
Page 386 and 387:
Index Checking Checking the Content
Page 388 and 389:
Index f2hs f2hs (Converting an Abso
Page 390 and 391:
Index Example of a Search when ther
Page 392 and 393:
Index -mlf Specification for Sectio
Page 394 and 395:
Index Specifies to Prevent the Inte
Page 396 and 397:
Index Entry Address Specification (
Page 398 and 399:
Index Types of Section Contents....
Page 400 and 401:
Index 386
show all

Linkage Kit Manual V6-00 - Fujitsu

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?