Linkage Kit Manual V6-00 - Fujitsu

CHAPTER 13 SPECIFICATIONS OF AN OBJECT FORMAT CONVERTER
13.2 Types of Object Format Converters
The command for an object format converter is x2ys, where the x represents the object
format of an input file and the y represents the object format of an output file.
An alphabetical character assigned in the x and y format means one of the following
formats:
• f:Absolute format load module that a linker outputs
• m:S format
• h:HEX format (HEX8/HEX16/HEX32)
• b:Binary data format
• i:HEX8 format (Only HEX8)
• e:HEX16 format (Only HEX16)
■ Types of Load Module Converters
■ Format Adjuster
■ Binary Converter
Use the commands in Table 13.2-1 to convert an object format
f2ms is used for conversion to the S format.
f2hs is used for conversion to the HEX format.
It is enabled to convert to the HEX8 format using f2is and to the HEX16 format using f2es, but it is
recommended to use f2hs corresponding HEX8/HEX16/HEX32.
Table 13.2-1 Conversions Made by Load Module Converters
Command name
f2ms
f2hs
f2is
f2es
The S Format Adjuster formats an object file in the S format and the HEX format. For details, see
"CHAPTER 16 FORMAT ADJUSTER (m2ms, h2hs)".
An object file in the S format and the HEX format is converted to binary data (a memory image) and output
into a converted file. For details, see "CHAPTER 17 BINARY CONVERTER (m2bs, h2bs)".
■ Types of Other Converters
Conversion
Absolute format load module to S format
Absolute format load module to HEX8/HEX16/HEX32 format
Absolute format load module to HEX8 format
Absolute format load module to HEX16 format
Use the commands in Table 13.2-2 to convert an object format.
Table 13.2-2 Conversions Made by Other Converters
Command name
m2is
m2es
i2ms
e2ms
S format to HEX8 format
S format to HEX16 format
HEX8 format to S format
HEX16 format to S format
Conversion
256 PART IV OBJECT FORMAT CONVERTERS