Linkage Kit Manual V6-00 - Fujitsu

CHAPTER 10 OPTIONS OF A LIBRARIAN
10.2.9 Specifying the Number of Columns Per Line of a List
(-pw)
Use this option to change the number of columns per line of a list from its default (80
characters).
■ Specifying the Number of Columns Per Line of a List (-pw)
[Format]
-pw < Number of columns > ( Default: 80 )
[Parameter]
Specify between 80 and 1023 inclusive.
[Descriptions]
Specify the number of columns to be printed per line of a list file.
Use this option when the default number of columns causes a long symbol name, section name, or
module name to extend over two lines, making it difficult to comprehend.
At the default number of columns (80), the number of characters displayable per line are as follows:
• Module name : 21 characters
• Section name : 19 characters
• Symbol name : 34 characters
If the -m option is not specified, this option is invalid.
[Example]
flibs syslib.lib -m libx.mp2 -pw 90
The number of columns per line of a list is changed to 90.
In this case, the number of characters displayable per line for each name are as follows:
• Module name : 31 characters
• Section name : 29 characters
• Symbol name : 39 characters
Note:
In a list of a librarian, specifying the number of columns per line in the -pw option changes the
number of characters displayed per line for the module name, section name, and symbol name.
Since one line of a symbol name is separated on the screen into two fields on the left and right,
specifying twice the number of characters in the longest symbol name plus 12 will display an easyto-understand
list.
230 PART III LIBRARIAN