Linkage Kit Manual V6-00 - Fujitsu

18.2 m2es (Converting a S Format File into the HEX16 Format)
18.2 m2es (Converting a S Format File into the HEX16 Format)
A S format file is converted into the HEX16 format.
The data at the addresses 0 through 0xFFFFF is to be converted.
■ m2es (Converting a S Format File into the HEX16 Format)
[Function]
The m2es command converts a S format file into the HEX16 format.
Figure 18.2-1 m2es (Converting S Format File into HEX16 Format)
S format file
m2es
HEX16 format file
(.mhx)
(.ehx)
Note:
The S format can represent the addresses 0 through 0xFFFFFFFF. However, when converted into
the HEX16 format, the data allocated at the addresses 0x100000 and higher is truncated.
When using this command, be careful of the range of addresses in the conversion source.
PART IV OBJECT FORMAT CONVERTERS 303