Linkage Kit Manual V6-00 - Fujitsu

CHAPTER 18 OTHER CONVERTERS
18.1 m2is (Converting a S Format File into the HEX8 Format)
A S format file is converted into the HEX8 format.
Data at the addresses 0 through 0xFFFF is to be converted.
■ m2is (Converting a S Format File into the HEX8 Format)
[Function]
The m2is command converts a S format file into the HEX8 format.
Figure 18.1-1 m2is (Converting S Format File into HEX8 Format)
S format file
m2is
HEX8 format file
(.mhx)
(.ihx)
Note:
The S format can represent the addresses 0 through 0xFFFFFFFF. However, when converted into
the HEX8 format, the data allocated at the addresses 0x10000 and higher is truncated.
When using this command, be careful of the range of addresses in the conversion source.
Since the HEX8 format file consists of data records and a trailer record, the starting address
information in the S format will be lost.
302 PART IV OBJECT FORMAT CONVERTERS