SYCON.net PROFIBUS DP Slave DTM

Appendix 130/132
13.2 User Rights
13.2.1 Settings
User-rights are set within the FDT-container. Depending on the level the
configuration is accessible by the user or read-only.
To access the Settings, Configuration, Device Description and
Diagnosis panes of the PROFIBUS DP Slave DTM you do not need
special user rights. Also all users can select the decimal or hexadecimal
Display mode or sort table entries.
Note: To edit, set or configure the parameters of the Settings and
Configuration panes, you need user rights for Maintenance, for Planning
Engineer or for Administrator.
The Device Description panes do not contain any editable elements. The
indicated values in are only for information purposes.
The following tables give an overview of the user right groups and which
user rights you need to configure the single parameters.
Observer Operator Maintenanc
e
Planning
Engineer
Administrator
Driver D D X X X
Selecting the Driver - - X X X
Configuring the Driver - - X X X
Device Assignment D D X X X
Scanning for Devices - - X X X
Selecting the Device (with or
- - X X X
without firmware)
Selecting the Device once more - - X X X
(with Firmware)
Firmware Download D D X X X
Table 66: Settings (D = Displaying, X = Editing, Configuring)
13.2.2 Configuration
Observer Operator Maintenanc
e
Planning
Engineer
Administra
tor
General D D X X X
Modules D D X X X
Parameter D D X X X
Groups D D X X X
Extensions D D X X X
DPV1 D D X X X
Address Table D D X X X
Device Settings D D X X X
Table 67: Configuration (D = Displaying, X = Editing, Configuring)
DTM for Hilscher PROFIBUS DP Slave Device | Configuration of Hilscher Slave Devices
DOC091001OI07EN | Revision 7 | English | 2011-09 | Released | Public © Hilscher, 2009-2011