SYCON.net PROFIBUS DP Slave DTM

Configuration 66/132
4.9.1 Start of Bus Communication
Figure 39: Device Settings > Start of Bus Communication
4.9.2 Application Monitoring
If Automatically by device is selected, the PROFIBUS DP Master device
starts with the data exchange on the bus after the initializing has been
ended.
When Controlled by application is selected, the application program must
activate the data exchange on the bus.
Note: The setting options under Start of Bus Communication for client
specific variants of the configuration software can differ from the setting
options displayed here.
Figure 40: Device Settings > Application Monitoring
The Watchdog time determines the time within which the device watchdog
must be re-triggered from the application program while the application
program monitoring is activated. When the watchdog time value is equal to
0 the watchdog is deactivated and the application program monitoring is
deactivated too.
The permissible range of values of the watchdog time is 20 to 65535. By
default the watchdog time value equals to 1000 ms.
Watchdog time
Permissible range of values
Default
The software watchdog is deactivated.
Table 21: Range of Value / Value for the Watchdog time
Range of Value / Value
20 … 65535 ms
1000 ms
0 ms
Note: The setting options under Application Monitoring for client
specific variants of the configuration software can differ from the setting
options displayed here.
DTM for Hilscher PROFIBUS DP Slave Device | Configuration of Hilscher Slave Devices
DOC091001OI07EN | Revision 7 | English | 2011-09 | Released | Public © Hilscher, 2009-2011