SYCON.net PROFIBUS DP Slave DTM

Configuration 56/132
4.4 Parameters
Important: For the option Device-Settings > Configuration Data Flag >
Configuration from Master and if in the network project the PROFIBUS
DP Slave DTM is dropped to the root busline (Stand-Alone Slave), the
Slave device uses the configuration, which the Master device sends via
PROFIBUS to the Slave device and the configuration step: „Set Module
Parameters“ can be used for the default configuration or is to be omitted.
The parameters of the window Parameters are relevant, if the Slave
device DTM icon is dropped to the Master bus line, as these parameters
then are transferred to the PROFIBUS DP Master DTM and thus the
Master is configured.
The pane Parameter allows it to change the parameter settings of the
modules.
Figure 28: Configuration > Parameter
If default parameters are available in the GSD file of the Slave, they are
automatically inserted.
Some of the DP Slave devices require further Parameter data, for instance
in order to change a measuring limit or a value range. This type of data is
manufacturer and slave specific. The meaning of the parameters is
determined by the device manufacturer. The explanations can be taken
from the manufacturers’ manual.
• Module
In the Module field the module which should be displayed has to be
selected. The modules have to be assigned in the Configuration before
(see section Modules on page 53).
• Parameter and Value
The Values of the Parameters can be changed by making a double click on
the parameter.
The meaning of the single Parameters can be found in the manual of the
device manufacturer.
Figure 29: Change Parameter Values
DTM for Hilscher PROFIBUS DP Slave Device | Configuration of Hilscher Slave Devices
DOC091001OI07EN | Revision 7 | English | 2011-09 | Released | Public © Hilscher, 2009-2011