SYCON.net PROFIBUS DP Slave DTM

Extended Diagnosis 80/132
7.4 PROFIBUS_DL
7.4.1 Busparameter
Under Extended Diagnosis > PROFIBUS_DL > Busparameter the values
of the configured bus parameters are displayed which are active at the bus.
Figure 50: Extended Diagnosis > PROFIBUS_DL > Busparameter
Bus Parameters
Station Address
Baud Rate
Slot time (tBit)
Min. Station Delay
Time (tBit)
Max. Station Delay
Time (tBit)
Meaning
The Station Address is the individual device address of the Master device on the bus.
Value range: 0 .. 125
The Baud Rate is the data transfer speed: number of Bits per second.
The Baud Rate must be set to be the same for all devices on the bus. The result of
changing the Baud rate is that all other parameters must be re-calculated.
Baud Rate Bit time (t Bit ) Max cable length (type A)
9,6 kBit/s
19,2 kBit/s
31,25 kBit/s
45,45 kBit/s
93,75 kBit/s
187,5 kBit/s
500 kBit/s
1500 kBit/s
3000 kBit/s
6000 kBit/s
12000 kBit/s
104,2 us
52,1 us
32 us
22 us
10,7 us
5,3 us
2 us
666,7 ns
333,3 ns
166,7 ns
83,3 ns
1200 m
1200 m
1200 m
1200 m
1200 m
1000 m
400 m
200 m
100 m
100 m
100 m
'Wait for receipt' – Monitoring time of the sender (Requestor) of telegram for the
acknowledgement of the recipient (Responder). After expiration, a retry occurs in
accordance with the value of 'Max. telegram retries'.
Value range: 37 .. 16383 (The default value depends from the baud rate.)
This is the shortest time period that must elapse before a remote recipient (Responder)
may send an acknowledgement of a received query telegram. The shortest time period
between the reception of the last Bit of a telegram to the sending of the first Bit of a
following telegram.
Value range: 1 .. 11 . 65535
This is the longest time period that must elapse before a Sender (Requestor) may send a
further query telegram. Greatest time period between the reception of the last Bit of a
telegram to the sending of the first Bit of a following telegram.
The Sender (Requestor, Master) must wait at least for this time period after the sending
of an unacknowledged telegram (e.g. Broadcast only) before a new telegram is sent.
Value range: 1 .. 65535 (The default value depends from the baud rate.)
DTM for Hilscher PROFIBUS DP Slave Device | Configuration of Hilscher Slave Devices
DOC091001OI07EN | Revision 7 | English | 2011-09 | Released | Public © Hilscher, 2009-2011