SYCON.net PROFIBUS DP Slave DTM

Extended Diagnosis 79/132
7.3 IniBatch Status
Figure 49: Extended Diagnosis > [Folder Name] > IniBatch Status Example Display
Name
Communication Channel
Current State
IniBatch Result
OpenDbm Result
SendPacket Result
Confirmation Result
Last Packet Number
Last Packet Command
Last Packet Length
Last Packet Destination
Description
Number of the communication channel used by the device.
0 =Idle;
1 =IniBatch packets in progress;
2 =Retrying to send last packet;
3 = Error
0 = Ok;
1 = No DBM file;
2 = No Packet table;
3 = No data set available;
4 = Data set is shorter than packet length;
5 = Packet Buffer is shorter than Packet length;
6 = Invalid packet destination;
7 = Logical queue not defined
8 = Send packet failed;
9 = Too many retries;
10 = Error in confirmation packet status
Error when opening the IniBatch data base
Under "OpenDbm Result" the error code is typed in, when
"IniBatch Result" == "No DBM file" (1) is.
Error when sending a packet
Under "SendPacket Result" the error code is typed in, when
"IniBatch Result" == “send packet failed" (8) is.
Confirmation error when sending packets
Under "Confirmation Result" the packet specific error code
from the ulSta is typed in, when "IniBatch Result " == "Error
in confirmation packet status" (10) is.
Value depends by the communication system.
Value depends by the communication system.
Value depends by the communication system.
Value depends by the communication system.
Table 33: Extended Diagnosis > [Folder Name] > IniBatch Status
The task status "Confirmation Result" is bus specific. The other task
statuses are rcx-related error codes.
DTM for Hilscher PROFIBUS DP Slave Device | Configuration of Hilscher Slave Devices
DOC091001OI07EN | Revision 7 | English | 2011-09 | Released | Public © Hilscher, 2009-2011