GE863-QUAD / PY Software User Guide

More documents

Recommendations

Info

GE863-QUAD / PY Software User Guide 1vv0300746 Rev. 1 - 23/10/06 NCP (IP) Configure Request NCP (IP) Configure Acknowledge At this point the TCP/IP - PPP protocol stack is up and data packets can be exchanged. Explanation of TCP/IP and PPP protocol stack is beyond the scope of this document. Further information on the LCP protocol and PPP protocol definition can be found in the RFC1661. Further information on the PAP protocol definition can be found in the RFC1334. Further information on the IPCP protocol definition can be found in the RFC1332. NOTE: The CONNECT result code is raised before complete GPRS connection establishment. Reproduction forbidden without Telit Communications S.p.A. written authorization - All Right reserved page 106 of 117
GE863-QUAD / PY Software User Guide 1vv0300746 Rev. 1 - 23/10/06 4.4 GPRS data state exit LCP Terminate Request LCP Terminate Acknowledge • Wait for NO CARRIER response. or alternatively: • send escape sequence: +++ • wait for 2s ( default silence time) • wait for response: Response Reason Action OK Now GE863-QUAD / PY is in proceed ahead command mode ERROR some error occurred Check command syntax and timing and retry NO CARRIER Connection has been closed Proceed ahead • send command ATH • wait for response: Response Reason Action OK The GPRS connection has been closed ERROR some error occurred Check command syntax and retry Reproduction forbidden without Telit Communications S.p.A. written authorization - All Right reserved page 107 of 117
Page 1 and 2:
GE863-QUAD / PY Software User Guide
Page 3 and 4:
Page 5 and 6:
Page 7 and 8:
Page 9 and 10:
Page 11 and 12:
Page 13 and 14:
Page 15 and 16:
Page 17 and 18:
2.5.2.3 Provide SIM PIN (only if re
Page 19 and 20:
Page 21 and 22:
Page 23 and 24:
Page 25 and 26:
For example: 1 - Let's assume that
Page 27 and 28:
Page 29 and 30:
Page 31 and 32:
Page 33 and 34:
Page 35 and 36:
Page 37 and 38:
Page 39 and 40:
AT+CPBR=7 the response may look lik
Page 41 and 42:
3.1.5 Phonebook entry Delete As fir
Page 43 and 44:
Page 45 and 46:
3.2.1.1 Set the extended incoming c
Page 47 and 48:
Page 49 and 50:
Page 51 and 52:
Page 53 and 54:
Page 55 and 56: GE863-QUAD / PY Software User Guide
Page 61 and 62: • wait for OK GE863-QUAD / PY Sof
Page 63 and 64: - Data Coding Scheme - page number
Page 95 and 96: esponse: +CCLK="02/11/07,13:24:47"
Page 99 and 100: 4.1.1 CSD application example GE863
Page 105: GE863-QUAD / PY Software User Guide
Page 111 and 112: MAIL FROM: GE863-QUAD / PY Softwar
Page 117: GE863-QUAD / PY Software User Guide
show all

GE863-QUAD / PY Software User Guide

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?