GE863-QUAD / PY Software User Guide

3.2.1.1 Set the extended incoming call indication
• Send command AT+CRC=
GE863-QUAD / PY Software User Guide
1vv0300746 Rev. 1 - 23/10/06
where:
is the operation mode selected:
0 – extended results Disabled (device reports RING only)
1 – extended results Enabled (device reports +CRING: indication)
• wait for OK response
3.2.2 Identify the Caller
The GE863-QUAD / PY is able to identify the caller number and give indication of it before the call is
answered.
The calling number is presented after each RING or +CRING indication in the format:
+CLIP: "",[,"",[,""[,]]]
OK
where:
is the phone number;
is the type of number:
145 – international numbering scheme
129 – national numbering scheme
is the subaddress of the calling party
is the type of subaddress
is an optional string type alphanumeric representation of corresponding to
the entry found in phonebook;
is the validity status of CLI presentation:
0 CLI valid.
1 CLI has been withheld by the originator.
2 CLI is not available due to interworking problems or limitation or originating network.
In order to use this feature you must enable the caller ID indication presentation, if feature is disabled
then no CLI indication is given after the RING or +CRING code.
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Right reserved page 45 of 117