GE863-QUAD / PY Software User Guide
GE863-QUAD / PY Software User Guide
GE863-QUAD / PY Software User Guide
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
<strong>GE863</strong>-<strong>QUAD</strong> / <strong>PY</strong> <strong>Software</strong> <strong>User</strong> <strong>Guide</strong><br />
1vv0300746 Rev. 1 - 23/10/06<br />
5 FTP OPERATIONS<br />
A set of AT commands is available to support the Ftp activities.<br />
A fist command is called #FTPTO (FTP Time-Out) which defines the time-out for FTP operations.<br />
The module has already a factory default time defined that is 100ms.<br />
If it is needed to be modified, the syntax is:<br />
AT#FTPTO[=]<br />
Parameter:<br />
- time-out in 100 ms units<br />
100..5000 - hundreds of ms (factory default is 100)<br />
Note: The parameter is not saved in NVM.<br />
Note: if parameter is omitted the behaviour of Set command is the same as Read command.<br />
Example:<br />
AT#FTPTO=1000<br />
OK<br />
(set the timeout to 100sec)<br />
5.1 Opening and Closing an FTP Connection<br />
With the command AT#FTPOPEN=,,, is possible to<br />
open the FTP connection.<br />
The parameters are:<br />
- string type, address and port of FTP server (factory default port 21).<br />
- string type, authentication user identification string for FTP.<br />
- string type, authentication password for FTP.<br />
<br />
0 - active mode (default)<br />
1 - passive mode<br />
In order to close the FTP connection the command to be used is AT#FTPCLOSE.<br />
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Right reserved page 112 of 117