GE863-QUAD / PY Software User Guide

GE863-QUAD / PY Software User Guide
1vv0300746 Rev. 1 - 23/10/06
For example:
1- Let's assume you want to send a SMS that was written to the storage index position number 3. We
suppose you already have set up the device for text SMS mode as described on the previous
paragraphs:
command:
AT+CMSS=3
response:
+CMSS: 1
OK
In this case, the SMS was successfully sent to the destination and its network message reference
number is 1.
3.4.5 Sending a new SMS without storing it
A new SMS can be sent directly to the network without storing it.
• send command AT+CMGS=""
where:
: destination address
• wait for prompt ">"
• send SMS text (MAX 160 characters)
• end command with CTRL-Z character (0x1A hexadecimal) or abort command with ESC character
(0x1B hexadecimal)
• wait for response:
Response Reason Action
+CMGS:
Message has been successfully proceed ahead
sent. represents the
OK
message reference number.
ERROR some error occurred Enable the extended error
codes report (see par.2.5.2.1)
and retry.
+CMS ERROR: 330 SMSC address unknown Insert SMSC address (see par.
3.4.1.3)
+CMS ERROR: 41
"Temporary Failure", may be
that the device is not registered
Check for signal strength and
network registration (see par. 0)
on any network
+CMS ERROR: 331 No network service Check for signal strength and
network registration (see par. 0)
+CMS ERROR: 1 Unassigned number The destination address
number does not exist. Check it
and repeat command.
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Right reserved page 75 of 117