GE863-QUAD / PY Software User Guide
GE863-QUAD / PY Software User Guide
GE863-QUAD / PY Software User Guide
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>GE863</strong>-<strong>QUAD</strong> / <strong>PY</strong> <strong>Software</strong> <strong>User</strong> <strong>Guide</strong><br />
1vv0300746 Rev. 1 - 23/10/06<br />
AT+CBST==2, 0, 0 V.22 1200 transparent<br />
AT+CBST==3, 0, 0 V.23 1200/75 transparent<br />
AT+CBST==4, 0, 0 V.22Bis 2400 transparent<br />
AT+CBST==6, 0, 0 V.32 4800 transparent<br />
AT+CBST==7, 0, 0 V.32 9600 transparent<br />
AT+CBST==65, 0, 0 V.110 300 transparent<br />
AT+CBST==66, 0, 0 V.110 1200 transparent<br />
AT+CBST==68, 0, 0 V.110 / X.31 2400 transparent<br />
AT+CBST==70, 0, 0 V.110 / X.31 4800 transparent<br />
AT+CBST==71, 0, 0 V.110 / X.31 9600 transparent<br />
Once selected the appropriate and parameters from the table:<br />
• Send command AT+CBST=,0,<br />
• wait for OK response<br />
2.7.2 Phone number dialing (data call)<br />
2.7.2.1 Dial a given phone number<br />
• Send command ATD <br />
where:<br />
is the phone number to be dialed<br />
• wait for response:<br />
Response Reason Action<br />
CONNECT 9600<br />
The called modem is now on exchange data..<br />
line.<br />
BUSY The line called is busy retry later<br />
NO ANSWER<br />
The receiver did not answer the retry later<br />
call<br />
NO CARRIER<br />
The modem handshaking has<br />
not been successful<br />
check for mobile registration<br />
and signal strength (par. 0) and<br />
eventually retry.<br />
TIP: The response to the ATD command is returned after the modem handshaking, this takes<br />
about 30 seconds, so allow this time before doing anything.<br />
TIP: When the device is doing the handshake the issue of any character closes the handshake<br />
and aborts the call.<br />
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Right reserved page 29 of 117