GE863-QUAD / PY Software User Guide
GE863-QUAD / PY Software User Guide
GE863-QUAD / PY Software User Guide
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>GE863</strong>-<strong>QUAD</strong> / <strong>PY</strong> <strong>Software</strong> <strong>User</strong> <strong>Guide</strong><br />
1vv0300746 Rev. 1 - 23/10/06<br />
3.2.4.7 Unbarring all the Calls<br />
• Send command AT+CLCK=AB,0,<br />
where:<br />
is the network password required to change facility status<br />
• wait for response:<br />
Response Reason Action<br />
OK Barring is now disabled all calls will be allowed<br />
(unbarred)<br />
ERROR some error occurred Enable the extended error<br />
codes report (see par.2.5.2.1)<br />
and retry.<br />
+CME ERROR: 4<br />
operation not supported, the Check command syntax<br />
service required is not available<br />
+CME ERROR: 30 no network service Check for registration (see par.<br />
2.5.3.1) and signal strength.<br />
+CME ERROR: 16 wrong network password check network password and<br />
retry<br />
For example:<br />
1- Let's assume you want to disable all the barring services you might have previously activated and<br />
the network password of your operator is 0000:<br />
command:<br />
AT+CLCK=AB,0,0000<br />
response:<br />
OK<br />
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Right reserved page 56 of 117
Change language