GE863-QUAD / PY Software User Guide
GE863-QUAD / PY Software User Guide
GE863-QUAD / PY Software User Guide
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>GE863</strong>-<strong>QUAD</strong> / <strong>PY</strong> <strong>Software</strong> <strong>User</strong> <strong>Guide</strong><br />
1vv0300746 Rev. 1 - 23/10/06<br />
3.2.4.6 Barring/Unbarring All Outgoing International Calls except to Home<br />
Country<br />
• Send command AT+CLCK=OX,,<br />
where:<br />
is the operation selected:<br />
0 – Call Barring Disable (Unbarring)<br />
1 – Call Barring Enable (Barring)<br />
is the network password required to change facility status<br />
• wait for response:<br />
Response Reason Action<br />
OK<br />
Barring is now enabled/disabled all outgoing international calls<br />
except to Home Country will be<br />
barred/unbarred<br />
ERROR some error occurred Enable the extended error<br />
codes report (see par.2.5.2.1)<br />
and retry.<br />
+CME ERROR: 4<br />
operation not supported, the Check command syntax<br />
service required is not available<br />
+CME ERROR: 30 no network service Check for registration (see par.<br />
2.5.3.1) and signal strength.<br />
+CME ERROR: 16 wrong network password check network password and<br />
retry<br />
For example:<br />
1- Let's assume you want to bar all the outgoing international calls except the ones towards the Home<br />
Country and the network password of your operator is 1234:<br />
command:<br />
AT+CLCK=OX,1,1234<br />
response:<br />
OK<br />
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Right reserved page 55 of 117