Repair Kits Available By Part Number Section 2 Page - GAMECO

Figure 4D: Exploded View of
Flomatic ® Valve
27
44
28
29
30
43
42
31
33
34
32
35
36
41
10
9
37
38
39
40
47
NOTE: Parts not identified by key numbers are not available individually. They must be purchased in an assembly.
Testing
1. Attach an air fi tting to the 1 /4" tee (#41) on the side of the
valve body.
2. Using 25 psi compressed air, pressurize the valve and bleed it
down several times, check the following features:
Figure 5
Tightening Sequence
A. Smooth valve operation. The valve piston should have a fl uid
operation. It should not stick or jump.
1 - 5 - 3 - 7 - 2 - 6 - 4 - 8
B. Indicating Slot (#36) Position. The indicator on the side of the
valve should be horizontal when the valve is closed and vertical
when the valve is open. It should rotate counterclockwise
as the valve is opening.
8
1
2
3. After testing, the strainer (#3) can be secured to the cylinder.
7
3
Re-Installing the Flomatic in the Container
1. Install new gaskets (#45, #46) on the inlet and outlet side
of valve.
2. Tighten the stud nuts gradually in a sequence of alternate and
opposite direction. See Figure 5.
6
5
4
3. Pressurize the container with vapor, check all fittings
and flange connections for leaks using a suitable leak
detection solution.
PAGE 5