1 Turn off the power of the printer. - Van Mechelen

GS V m ......... (1)
GS V m n ..... (2)
[Function]
[Code]
Cutting the paper
(1) HH
(2) HH
[Range] (1) m = 1, m = 49
(2) m = 66
0 n 255
[Outline]
Performs the specified paper cutting.
m
Function
1,49 Partial cut (Leaving a bridge area uncut)
66
Paper feed by “cut position + {n × basic calculation
pitch}”and partial cut (Leaving a bridge area uncut)
[Caution]
• Fully cut for the label sheet specs.
• In STANDARD MODE, this command only works when it is
entered at the beginning of a line.
For (1):
• A partial cut (Leaving a bridge area uncut) is executed.
For (2):
• If n = 0, the paper is fed to the cut position, and then cut. If n
≠ 0, the paper is fed by “n × basic calculation pitch” inches
past the cut position, and then cut.
• The basic calculation pitch is set by GS P.
The paper feed amount is calculated with the vertical basic
calculation pitch (y).
A fraction resulting from the calculation is corrected with the
minimum pitch of the mechanism, and the remainder is
omitted.
CAUTION:
When using label sheet:
• Be sure to cut the base sheet at every label gap. Otherwise, the cutter performance
will be immensely degraded.
• Never open the printer cover while printing as proper print operation may not be
guaranteed. Opening the printer cover may alter label length setting or other
parameters.
• Never use label rolls with different label sizes or label gaps as proper print
operation will not be guaranteed.
— 109 —