1 Turn off the power of the printer. - Van Mechelen
1 Turn off the power of the printer. - Van Mechelen
1 Turn off the power of the printer. - Van Mechelen
- No tags were found...
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
(2) If a sufficient area cannot be provided as a result <strong>of</strong> step<br />
(1), <strong>the</strong> print area is extended toward <strong>the</strong> left (So, <strong>the</strong> left<br />
margin is decreased).<br />
Printable Area<br />
Left Margin<br />
(2) The left margin<br />
is trimmed<br />
A<br />
Print Area Width<br />
(1)<br />
Extended<br />
toward<br />
<strong>the</strong> right<br />
(3) If a sufficient area cannot be provided as a result <strong>of</strong> step<br />
(2), <strong>the</strong> right spacing is trimmed.<br />
• When mapping a bit image (Or downloaded bit image), if <strong>the</strong><br />
print area is narrower than <strong>the</strong> minimum width <strong>of</strong> <strong>the</strong> bit image<br />
(Two dots for single density, or one dot for double density),<br />
only <strong>the</strong> line for that image is handled as follows:<br />
(1) The print area is extended toward <strong>the</strong> left (So, <strong>the</strong> left<br />
margin is decreased) until it is equal to <strong>the</strong> minimum width<br />
<strong>of</strong> <strong>the</strong> image, but not wider than <strong>the</strong> printable area.<br />
[Default]<br />
[See Also]<br />
nL=64, nH=2 (When 58mm wide paper is used: nL=176, nH=1)<br />
Since <strong>the</strong> default value varies depending on <strong>the</strong> number <strong>of</strong><br />
columns, refer to “Defing <strong>the</strong> print area in PAGE MODE; ESC<br />
W”on page 83, for more information.<br />
GS L, GS P<br />
— 111 —