1 Turn off the power of the printer. - Van Mechelen

5.2 Table for Setting DIP Switches
DIP switch 1
No. Function ON OFF Factory setting
1 Auto cutter Available Not available ON
2 unused — — OFF
3 Paper width 58 mm 80 mm OFF
4 Print columns *
42(80 mm) columns 48(80 mm) columns
30(58 mm) columns 36(58 mm) columns
OFF
5 CR mode LF Operation Ignored OFF
6 Input buffer 72 bytes 4K bytes OFF
7
ON
Print density (See the table below.)
8 OFF
* : It will be different according to the setting of paper width (DS1 – 3) and font A or B.
Print density (DIP switch 1)
Print density Level 1 Level 2 Level 3 Level 4
No. (Light) (Standard) (Slightly dark) (Dark)
7 OFF ON OFF ON
8 OFF OFF ON ON
Note: If print density is set to level 2 or over, print speed may decrease.
— 24 —