1 Turn off the power of the printer. - Van Mechelen

4.5 Adjusting the Paper Near-end Sensor
1
Open the printer cover.
2
Push the sensor knob in the
direction of arrow 1 to disengage its
claw (Or unlock the sensor unit), and
then adjust the sensor unit to a
desired paper remaining position
within the range shown by arrow 2.
3
The following table shows the
relationship between adjustment
positions and levels of paper roll
remaining. (A rough guide)
Adjustment Level of paper remaining
position (Paper roll outside dia. mm)
1 φ18
2 φ21
3 φ24
4 φ27
* When specified paper rolls are used.
Sensor knob
Arrow 1
Arrow 2
4 3 2 1
Adjustment
position
Sensor unit
CAUTION:
Use the level of paper remaining (Paper-roll outside diameter) just as a guide as it varies
depending on the particular printer and paper rolls used.
— 16 —