1 Turn off the power of the printer. - Van Mechelen
1 Turn off the power of the printer. - Van Mechelen
1 Turn off the power of the printer. - Van Mechelen
- No tags were found...
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
GS \ nL nH<br />
[Function]<br />
[Code]<br />
Specifying <strong>the</strong> relative vertical position <strong>of</strong> a character in<br />
PAGE MODE<br />
HH<br />
[Range] 0 nL 255<br />
0 nH 255<br />
[Outline]<br />
[Caution]<br />
This command is used in PAGE MODE to specify <strong>the</strong> vertical<br />
position <strong>of</strong> a character in <strong>the</strong> data mapping start position, in a<br />
relative position with respect to <strong>the</strong> current position. The next<br />
data mapping start position will be at a point [(nL + nH × 256)×<br />
basic calculation pitch] inches away from <strong>the</strong> current position.<br />
• This command is ignored when PAGE MODE is not selected.<br />
• If a new position is specified for a character located beneath<br />
<strong>the</strong> current position, it should be specified as positive (+). If it<br />
is above <strong>the</strong> current position, it should be negative (-).<br />
• A negative value is <strong>the</strong> complement <strong>of</strong> 65536. For example, to<br />
move <strong>the</strong> position by N pitches up, specify it as:<br />
nL + nH × 256 = 65536 - N<br />
• The specification <strong>of</strong> a relative position outside <strong>the</strong> specified<br />
print area is ignored.<br />
• Depending on <strong>the</strong> start point specified by ESC T, this command<br />
acts as follows:<br />
(1) If <strong>the</strong> start point is <strong>the</strong> top left or bottom right, <strong>the</strong> command<br />
specifies <strong>the</strong> relative position in <strong>the</strong> paper feed direction<br />
(The character’s top-bottom direction) using <strong>the</strong> vertical<br />
basic calculation pitch (y).<br />
(2) If <strong>the</strong> start point is <strong>the</strong> top right or bottom left, <strong>the</strong> command<br />
specifies <strong>the</strong> relative position in <strong>the</strong> direction perpendicular<br />
to <strong>the</strong> paper feed (The character’s top-bottom direction)<br />
using <strong>the</strong> horizontal basic calculation pitch (x).<br />
• The basic calculation pitch is set by GS P.<br />
• Fractions resulting from calculations are corrected with <strong>the</strong><br />
minimum pitch <strong>of</strong> <strong>the</strong> mechanism, and <strong>the</strong> remainder is<br />
omitted.<br />
— 112 —