BD01 System â 40 ... 160 A - GRUP DAP

More documents

Recommendations

Info

CD-K System — 25 ... 40 A © Siemens AG 2007 General data 3 Type CD-K-1402 CD-K-1403 CD-K-1404 CD-K-2404 (/2) Conductors Rated insulation voltage U i V AC/DC 400/400 400/400 400/400 400/400 Overvoltage category/pollution degree III/3 III/3 III/3 III/3 Rated operational voltage U e V AC 400 400 400 400 Frequency Hz 50 ... 60 50 ... 60 50 ... 60 50 ... 60 Rated current I e = conventional thermal current at max. 40 °C and 35 °C on a 24 h average Feeder units, conductor cross-sections A 40 40 40 2 × 40 Impedance of conductors at 50 Hz and 20 °C •Resistance R 20 mΩ/m 3.55 3.55 3.55 3.69 • Reactance X 20 mΩ/m 0.40 0.40 0.40 0.13 • Impedance Z 20 mΩ/m 3.57 3.57 3.57 3.69 Impedance of conductors under fault conditions • AC resistance R F mΩ/m 5.61 5.61 5.61 4.17 • Reactance X F mΩ/m 0.80 0.80 0.80 0.40 • Impedance Z F mΩ/m 5.67 5.67 5.67 4.18 Zero impedance according to IEC/EN 60909 (VDE 0102) •Resistance R 0 Phase to N mΩ/m 14.85 14.85 14.85 14.33 • Reactance X 0 Phase to N mΩ/m 0.99 0.99 0.99 0.78 • Impedance Z 0 Phase to N mΩ/m 14.88 14.88 14.88 14.33 •Resistance R 0 Phase to PE mΩ/m 9.87 9.87 9.87 5.15 • Reactance X 0 Phase to PE mΩ/m 1.02 1.02 1.02 0.74 • Impedance Z 0 Phase to PE mΩ/m 9.92 9.92 9.92 5.21 Short-circuit strength Rated impulse withstand current I pk kA 3.6 3.6 3.6 3.6 Rated short-time withstand current I cw (t = 1 s) kA 0.85 0.85 0.85 0.85 Rated short-time withstand current I cw (t = 0.1 s) kA 2.4 2.4 2.4 2.4 Conductors Number of active conductors 2 3 4 2 × 4 (1 × 4, 1 × 2) Conductor cross-section • L1, L2, L3 mm 2 5.0 5.0 5.0 5.0 •N mm 2 5.0 5.0 5.0 5.0 • PE (enclosure) = Cu mm 2 11 11 11 11 Conductor material Cu Cu Cu Cu Fire load kWh/m 0.12 0.18 0.24 0.48 Max. thermal load, I 2 t value A 2 s × 10 3 720 720 720 720 Fixing intervals m 3 3 3 3 at normal mechanical load Position of tap-off points depending on the type: on one side at 0.5 m or 1 m intervals, on both sides at 0.5 m intervals or alternating from side to side and offset at 0.5 m intervals Version Type L1, L2, L3 N PE Tap-off plugs min. mm 2 max. mm 2 Entry feeder unit CD-K-...-EA 2.5 6 (f) 10 (e, m) End feeder unit CD-K-...-EE 2.5 6 (f) 10 (e, m) min. mm 2 max. mm 2 2.5 6 (f) 10 (e, m) 2.5 6 (f) 10 (e, m) f = flexible with end sleeve, so = solid, st = stranded min. mm 2 max. mm 2 2.5 6 (f) 10 (e, m) 2.5 6 (f) 10 (e, m) Type CD-K-A... Version 3- or 5-pole Rated current I e A 10 or 16 Switching capacity according to IEC/EN 60947-3 • Utilization category AC-20B Connection without or with permanently attached cable; the PE operates as a leading contact during connection and as a delayed contact during removal Fuses without or with fuse holder for cylindrical fuses 8.5 mm × 31.5 mm, type gG (IEC) or type gL (VDE) (quick) 3/8 Siemens LV 70 · 2006
© Siemens AG 2007 CD-K System — 25 ... 40 A Trunking units ■ Selection and ordering data Version Length Conductor Tap-off points DT Type Order No. PS* Weight Number Distance per unit approx. m m kg Rated current I e = 30 A, tap-off points on one side Trunking units sheet steel enclosure, 3 3-pole 3 1 A CD-K-1302-3 BVP:211151 6 units 2.450 color similar to RAL 9002 (white-gray), L1 codable tap-off points N PE NSV0_00236 3 4-pole 3 1 A CD-K-1303-3 BVP:211152 6 units 2.550 NSV0_00201 L2 L1 N PE NSV0_00237 2 5-pole 2 1 A CD-K-1304-2 BVP:211153 6 units 1.850 L3 L2 L1 N PE NSV0_00238 3 5-pole 3 1 A CD-K-1304-3 BVP:211154 6 units 2.650 L3 L2 L1 N PE NSV0_00238 3 5-pole 5 0.5 A CD-K-1304-3-05 BVP:211155 6 units 2.650 3 L3 L2 L1 N PE NSV0_00238 Rated current I e = 40 A, tap-off points on one side Trunking units sheet steel enclosure, 3 3-pole 3 1 A CD-K-1402-3 BVP:211156 6 units 2.450 color similar to RAL 9002 (white-gray), L1 codable tap-off points N PE NSV0_00236 3 4-pole 3 1 A CD-K-1403-3 BVP:211157 6 units 2.550 NSV0_00201 L2 L1 N PE NSV0_00237 2 5-pole 2 1 A CD-K-1404-2 BVP:211158 6 units 1.850 L3 L2 L1 N PE NSV0_00238 3 5-pole 3 1 A CD-K-1404-3 BVP:211159 6 units 2.650 L3 L2 L1 N PE NSV0_00238 3 5-pole 5 0.5 A CD-K-1404-3-05 BVP:211160 6 units 2.850 L3 L2 L1 N PE NSV0_00238 * You can order this quantity or a multiple thereof. Siemens LV 70 · 2006 3/9
Page 1 and 2: © Siemens AG 2007 Catalog LV 70
Page 3 and 4: © Siemens AG 2007 SIVACON 8PS Busb
Page 5 and 6: © Siemens AG 2007 Introduction 1/2
Page 7 and 8: © Siemens AG 2007 Low-Voltage Cont
Page 9 and 10: © Siemens AG 2007 oriented enginee
Page 11 and 12: DATE: EMPLOYEE COST CENTER PAY PERI
Page 13 and 14: © Siemens AG 2007 Universal power
Page 15 and 16: © Siemens AG 2007 Busbar Trunking
Page 27 and 28: © Siemens AG 2007 CD-K System - 25
Page 29 and 30: © Siemens AG 2007 CD-K System —
Page 33: © Siemens AG 2007 CD-K System —
Page 51 and 52: © Siemens AG 2007 BD01 System - 40
Page 53 and 54: © Siemens AG 2007 BD01 System —
Page 77 and 78: NSV0_00984 NSV0_00985 © Siemens AG
Page 79 and 80: 0,10 m © Siemens AG 2007 BD01 Syst
Page 85 and 86:
© Siemens AG 2007 BD01 System —
Page 87 and 88:
Page 89 and 90:
Page 91 and 92:
Page 93 and 94:
Page 95 and 96:
© Siemens AG 2007 BD2 System - 160
Page 97 and 98:
© Siemens AG 2007 BD2 System — 1
Page 99 and 100:
Page 101 and 102:
NSV0_00118 NSV0_00124 NSV0_00119 ©
Page 103 and 104:
Page 105 and 106:
NSV0_00148 © Siemens AG 2007 BD2 S
Page 107 and 108:
Page 109 and 110:
Page 111 and 112:
Page 113 and 114:
Page 115 and 116:
Page 117 and 118:
Page 119 and 120:
Page 121 and 122:
Page 123 and 124:
Page 125 and 126:
Page 127 and 128:
Page 129 and 130:
Page 131 and 132:
Page 133 and 134:
Page 135 and 136:
Page 137 and 138:
Page 139 and 140:
Page 141 and 142:
Page 143 and 144:
Page 145 and 146:
Page 147 and 148:
NSV0_00460 NSV0_00459 NSV0_00458 NS
Page 149 and 150:
NSV0_00468 NSV0_00467 NSV0_00465 NS
Page 151 and 152:
NSV0_00470 NSV0_00470 NSV0_00470 ©
Page 153 and 154:
Page 155 and 156:
NSV0_00485 NSV0_00484 © Siemens AG
Page 157 and 158:
Page 159 and 160:
NSV0_00465 NSV0_00455 NSV0_00471 NS
Page 161 and 162:
NSV0_00462 NSV0_00464 NSV0_00464 NS
Page 163 and 164:
NSV0_00494 NSV0_00493 © Siemens AG
Page 165 and 166:
Page 167 and 168:
Page 169 and 170:
Page 171 and 172:
NSV0_00191 © Siemens AG 2007 BD2 S
Page 173 and 174:
Page 175 and 176:
Page 177 and 178:
Page 179 and 180:
Page 181 and 182:
Page 183 and 184:
Page 185 and 186:
Page 187 and 188:
Page 189 and 190:
Page 191 and 192:
Page 193 and 194:
Page 195 and 196:
Page 197 and 198:
Page 199 and 200:
Page 201 and 202:
Page 203 and 204:
Page 205 and 206:
Page 207 and 208:
Page 209 and 210:
Page 211 and 212:
11 © Siemens AG 2007 BD2 System
Page 213 and 214:
Page 215 and 216:
© Siemens AG 2007 Appendix 6/2 Glo
Page 217 and 218:
© Siemens AG 2007 Appendix Glossar
Page 219 and 220:
© Siemens AG 2007 Appendix Glossar
Page 221 and 222:
© Siemens AG 2007 Appendix Further
Page 223 and 224:
© Siemens AG 2007 Appendix Standar
Page 225 and 226:
© Siemens AG 2007 Appendix Siemens
Page 227 and 228:
© Siemens AG 2007 Appendix Custome
Page 229 and 230:
© Siemens AG 2007 Appendix Type re
Page 231 and 232:
© Siemens AG 2007 Catalogs of the
Page 233:
ens AG Busbar Trunking Systems CD-K
show all

BD01 System â 40 ... 160 A - GRUP DAP

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?

BD01 System â 40 ... 160 A - GRUP DAP