BD01 System – 40 ... 160 A - GRUP DAP

© Siemens AG 2007
BD2 System — 160 ... 1250 A
Introduction
Straight trunking units
Flexible junction units
NSV0_00097
NSV0_00095
Equipment
The trunking units are available in the following versions:
• Without tap-off points
• With tap-off points on both sides at intervals of 0.5 m, offset by
0.25 m (BD2.-2, BD2.-3) and at intervals of 1 m, offset by 0.5 m
(BD2.-1).
One clamp terminal is included as standard.
Fire barriers can be fitted (see "Fire Barriers", page 5/6).
The following lengths are available:
•3.25 m
•2.25 m
•1.25 m
• Optional lengths
Number of tap-off points
Length
Tap-offs on both sides
m
1.25 ... 2.25 2 ... 8
2.26 ... 3, 25 4 ... 12
On optional lengths, it may not be possible to fit tap-off units to
all tap-off points
Junction units
NSV0_00096
BD2-...-R
L-units
Left: Knee, rear;
BD2.-...-LH, BD2.-...-LH-X*, BD2.-...-LH-Y*, BD2.-...-LH-X*/Y*
Right: Knee, front;
BD2.-...-LV, BD2.-...-LV-X*, BD2.-...-LV-Y*, BD2.-...-LV-X*/Y*
X
X Y
Y
Left: Elbow, right;
BD2.-...-LR, BD2.-...-LR-X*, BD2.-...-LR-Y*, BD2.-...-LR-X*/Y*
Right: Elbow, left;
BD2.-...-LL, BD2.-...-LL-X*, BD2.-...-LL-Y*, BD2.-...-LL-X*/Y*
Z-units
Y
X
Y
NSV0_00098
NSV0_00100
X
X
Y
Equipment
Flexible copper conductors for the flexible junction units.
The L-units with configurable angle are available with a fixed
angle of 90° or any angle in 5° increments from 85° to 175°.
Z
Y
X
Z
NSV0_00102
5
All L and Z-units are available with
• Standard limb lengths of 0.36 m
• One or two limb lengths selectable from 0.36 m to 1.25 m.
Left: BD2.-...-ZH-Z*, BD2.-...-ZH-X*/Y*/Z* (rear)
Right: BD2.-...-ZV-Z*, BD2.-...-ZV-X*/Y*/Z* (front)
The junction units are supplied with one clamp terminal.
Y
NSV0_00104
X
Z
Y
Z
X
Left: BD2.-...-ZR-Z*, BD2.-...-ZR-X*/Y*/Z* (right)
Right: BD2.-...-ZL-Z*, BD2.-...-ZL-X*/Y*/Z* (left)
Siemens LV 70 · 2006
5/5