BD01 System – 40 ... 160 A - GRUP DAP

© Siemens AG 2007
BD01 System — 40 ... 160 A
Introduction
Universal fixing bracket
The universal fixing brackets can be used for wall and ceiling
mounting. The maximum fixing interval at normal mechanical
loads is 3 m for edgewise and 1.5 m for flat mounting.
At higher mechanical loads (e.g. pulling of plugs), an intermediate
support with an additional fixing bracket at the trunking unit
is recommended.
Once the fixing point is decided, the tabs on the fixing bracket
are pushed in to fix the trunking run.
Coding
The systems can be coded for different frequencies or voltages.
For this purpose, the BD01-K coding set can be fitted by the user
to the installed system at each tap-off point. Four coding positions
are possible.
NSV0_00063
NSV0_00060
Tap-off units can be coded on site by adapting the front.
BD01-B
Fixing brackets
These fixing brackets can be used for suspension of
flat-mounted trunking units. Also they can be fastened at the
connection points in order to increase the mechanical rigidity of
the trunking units.
NSV0_00064
BD01-BAP
Suspension bracket
The suspension brackets can be used for wall, ceiling and suspension
mounting of the system. They can be fitted at any point
of the trunking unit. The maximum fixing interval at normal mechanical
loads is 3 m for edgewise and 1.5 m for flat mounting.
At higher mechanical loads (e.g.pulling of plugs), an intermediate
support with an additional fixing bracket at the trunking unit
is recommended.
NSV0_00061
Sealing
Every tap-off point on the trunking unit can be sealed.
Feeder, junction, tap-off and ancillary equipment units can be
made sealable with additional components (please enquire).
Cable glands
For the feeder, tap-off and ancillary equipment units, use plastic
cable glands with strain relief (not included as standard).
Terminals
We recommend the use of Weidmüller or Phoenix screw terminals
for the N and PE conductor connections in tap-off and
ancillary equipment units.
4
NSV0_00062
BD01-BA
Siemens LV 70 · 2006
4/7