AT Commands Set

SIM5215_SIM5216 AT Command Manual
The command is used to set DCD pin to DCD mode or GPIO mode.
NOTE DCD mode is invalid currently.
SIM PIN References
NO Vendor
Syntax
Test Command
AT+CDCDMD=?
Read Command
AT+CDCDMD?
Write Command
AT+CDCDMD=
Responses
+CDCDMD: (list of supported s)
OK
Responses
+CDCDMD:
OK
Responses
OK
ERROR
Defined values
0 – DCD mode
1 – GPIO mode
Examples
AT+CDCDMD=0
OK
12.23 AT+CDCDVL Set DCD pin high-low in GPIO mode
Description
The command is used to set DCD pin high-low in GPIO mode.
NOTE The command will disable when DCD pin is DCD mode.
SIM PIN References
NO Vendor
Syntax
Test Command
AT+CDCDVL=?
Responses
+CDCDVL: (list of supported s)
OK
SIM5215_SIM5216_AT Command Manual_V1.13 226
1/13/2011