FELCOM 15 Operator's Manual K 7-10-09 - Furuno USA

4. INMARSAT C COMMUNICATIONS
TRANSMIT MESSAGE STATUS
The terminal unit displays transmit message status as follows:
Message Send failed. This appears if the message could not
be transmitted because of technical reasons such as satellite
malfunction, signal degradation, or no reply from LES. Try to
transmit the message again.
Message Send rejected. This appears when the LES rejects
the message because of non-technical reasons such as unpaid
subscriber's fee.
Message Send pending.This appears when the circuits at the
LES are busy. Your message will be transmitted when a circuit
becomes clear.
Transmitting a message to a station not registered on station list
1. Prepare message. For e-mail or SMS, set Text Mode in the Editor Setup
menu to Ascii. See paragraph 3.2.3. For e-mail attachment, prepare the
attachment and save it to a floppy disk. SMS messages over 160 characters
in length are sent in parts.
2. Press the [F3] key to display the Transmit menu.
3. Press the [1] key to show the Transmit Message menu.
Displays communication charge. See paragraph 2.6.1.
File Edit Transmit EGC Reports Logs Options Setup Position StopAlarm
Transmit
1. Transmit Message
2. Priority Cancel
Transmit Message
Normal
3. Message Request File Delivery Status Message now being edited Size 24
Station Name
Cost ********.**(US$)
Destination Type TELEX
Prefix Code
Country/Ocean Code
Station ID
Modem Type
---- * ---------+---------+---------+---------+---------+---------+---------<
Address
Subject
25 Char. [ Line 2/ 2 Col. 1 ] [Insert ]
Attach File
LES ID
Option
Confirmation
Send Delay
Delivery Delay
Code
ON
00:00
Immediate
IA5
[ TRANSMIT ]
Transmit message menu
4-8