FELCOM 15 Operator's Manual K 7-10-09 - Furuno USA
FELCOM 15 Operator's Manual K 7-10-09 - Furuno USA
FELCOM 15 Operator's Manual K 7-10-09 - Furuno USA
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
9. MAINTENANCE,<br />
TROUBLESHOOTING<br />
This chapter provides the information necessary for the maintenance and<br />
checking of the <strong>FELCOM</strong> <strong>15</strong>. Please review the safety information at the<br />
beginning of this manual before attempting any maintenance procedures.<br />
9.1 General Checking and Maintenance<br />
Turn off the power before conducting any maintenance procedures other than<br />
the cleaning of the terminal unit.<br />
NOTICE<br />
Do not apply paint, anti-corrosive sealant or contact spray<br />
to coating or plastic parts of the equipment.<br />
Those items contain organic solvents that can damage coating<br />
and plastic parts, especially plastic connectors.<br />
Cleaning the terminal unit<br />
Wipe the LCD carefully to prevent scratching, using tissue paper and an LCD<br />
cleaner. To remove dirt or salt deposits, use an LCD cleaner, wiping slowly with<br />
tissue paper so as to dissolve the dirt or salt. Change paper frequently so the<br />
salt or dirt will not scratch the LCD. Do not use solvents such as thinner, acetone<br />
or benzine for cleaning; they can remove paint and marks or deform the<br />
equipment.<br />
Checking connectors and earth terminal<br />
Check that the connectors and earth terminal on the terminal unit are tightly<br />
fastened. If the copper strap (earth material) has rusted, clean it.<br />
Floppy disk drive head<br />
The floppy disk is coated with a magnetic material which stores the information<br />
entered into the disk. If this material is damaged by foreign material adhering to<br />
the disk drive head it may not be possible to read from or write to the disk. Clean<br />
the head regularly with a cleaning floppy disk to prevent loss of data.<br />
When the power can’t be turned on<br />
When the terminal unit cannot be turned on do the following:<br />
• Check that the power cable connector on the rear panel of the terminal unit for<br />
tightness.<br />
• Check if the ship’s mains switchboard is turned on.<br />
• Have a qualified technician check the power voltage at the power connector<br />
on the rear of the terminal unit.<br />
9-1