FELCOM 15 Operator's Manual K 7-10-09 - Furuno USA
FELCOM 15 Operator's Manual K 7-10-09 - Furuno USA
FELCOM 15 Operator's Manual K 7-10-09 - Furuno USA
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
1. OPERATIONAL OVERVIEW<br />
1.5 Standby Display<br />
After the equipment is turned on and the diagnostic test has been conducted, the<br />
standby display appears, showing the system status monitor. The system status<br />
monitor provides various operating information. For a detailed description, see<br />
paragraph 8.4.<br />
File Edit Transmit EGC Reports Logs Options Setup Position StopAlarm<br />
Date<br />
Time<br />
Position LAT 34:30.00N<br />
LON 135:00.00E<br />
Waypoint LAT<br />
LON<br />
Course<br />
345.5 DEG<br />
Speed <strong>10</strong>.2 KTS<br />
Current NCS 344 (IOR) LOGOUT<br />
Current Channel NCS CC<br />
Current TDM NCS CC<br />
MES Status Idle<br />
GPS Status ****<br />
DCE Memory<br />
02-02-25<br />
01:32 (UTC)<br />
32818 Bytes free<br />
IMN: 443<strong>15</strong>67<strong>10</strong><br />
BBER<br />
C/N<br />
Send Level<br />
000<br />
OK (<br />
OK (<br />
0 dB)<br />
0)<br />
Rx AGC Level OK (254)<br />
REF Offset Freq<br />
Synthe Local<br />
VCXO Control<br />
OK (<br />
OK<br />
131<br />
0 Hz)<br />
Antenna Power Supply<br />
Water Temperature<br />
Water Current<br />
Direction<br />
Speed<br />
Depth<br />
OK<br />
68.2 DEG<br />
232 DEG<br />
1.9 KTS<br />
Current State: IDLE<br />
DCE F<strong>15</strong> Ver. ##<br />
Retuning<br />
02-02-25 01:32 (UTC)<br />
NCS: IOR LOGOUT LAT: 34:30.00N<br />
LON: 135:00.00E<br />
##: Program Version No. of RF CON Board<br />
Standby display<br />
After the diagnostic test has been completed, the equipment automatically starts<br />
synchronizing itself with a satellite. When the indication “Retuning” is replaced<br />
with “ SYNC(NCS), the synchronization process is completed. Then, you are<br />
ready to receiving EGC messages. For further details see paragraph 2.4.<br />
Note: When the caution shown below appears, it is necessary to change the<br />
LES ID in the distress alert setup to match current ocean region. For<br />
further details, see paragraph 6.2.<br />
CAUTION<br />
Pre-set LES ID for DISTRESS ALERT is invalid in the present ocean region.<br />
Please input preferred LES ID in the [Distress Alert Setup] menu.<br />
1-8
Change language