FELCOM 15 Operator's Manual K 7-10-09 - Furuno USA

7. OTHER FUNCTIONS
This chapter describes how to abort operation, scan NCS, choose EGC and
NCS channels and display LES information.
7.1 Aborting an Operation
You can abort transmission, receiving or scanning (on the NCS common
channel) as follows:
1. Press the [F7] key to display the Options menu.
Options
1. Login
2. Logout
3. Abort
4. Select NCS
5. Ocean Region
6. LES Information
7. Test
Options menu (when FELCOM functions as Inmarsat MES)
2. Press the [3] key to choose Abort.
Options
1. Login
2. Logout
3. Abort
4. Select NCS
5. Ocean Region
6. Test
Abort
Yes
Start
No
Abort screen
3. Yes is selected; press the [Enter] key to abort current operation.
The message “FORCED CLEARING” replaces “SENDING” or “RECEIVING”
at the bottom of the screen. When the process has been aborted, the
message “Process Aborted. Press any key to escape.” appears.
Note: If aborting is attempted in modes other than those mentioned above, the
message “Ignored: Can not abort current process.” appears.
7-1