Daelim B-Bone 125cc service manual.pdf - Mojo

FUEL SYSTEM
SCREW SET
ASSEMBLY
● Install the needle jet, needle jet holder, main jet and
slow jet.
● Tighten the pilot jet until it seat lightly, then turn it out
as much as number recorded during removal.
● Install the pilot jet rubber.
● Install the float valve set, float comp, float pin.
● Measure the float level with the float valve gauge.
FLOAT LEVEL : 13 mm
TOOL : FLOAT COMP LEVEL GAUGE
● Install the float chamber set.
● Install the stay plate set and 4 pan screws.
FLOAT CHAMBER SET
! NOTE
Be sure to replace the float chamber body O-ring
with the new one.
● Install the valve plate set, compression spring in the
vacuum piston comp.
TOP SET
! NOTE
Install the jet needle aligned with the grooves.
● Install the diaphragm cover with its cutout aligned with
the cover.
● Place the top set on the spring.
● Tighten the 2 special pan screws.
6-7