Daelim B-Bone 125cc service manual.pdf - Mojo

LH.CRANK CASE COVER/CONTINUOUSLY VARIABLE TRANSMISSION
COG
WIDTH
DRIVE BELT INSPECTION
● Check the drive belt for cracks, pry separation and
wear, replace as necessary.
● Measure the width of the drive belt as shown.
SERVICE LIMIT : 20.5mm
DRIVEN PULLEY SUB ASS’Y
! NOTE
Use only a genuine DAELIM replacement drive belt.
Do not get oil or grease on the drive belt or pulley
faces. Clean off any grease or oil before reinstalling.
DRIVE BELT INSTALLATION
● Turn the pulley clockwise and spread the face apart
while installing the drive belt and install the drive belt
to the driven pulley ass’y.
● Install the driven pulley sub ass’y on the drive belt.
● Install the drive belt to the movable drive face apart.
DRIVE BELT
DRIVEN PULLEY
● Temporarity install the driven pulley and flange nut.
● Hold the clutch outer using the universal holder and
tighten the flange nut with the specified torque.
! NOTE
Do not rotate the movable drive face to became
the original position until the driven pulley to
be installed completely to the drive shaft.
8-4