Daelim B-Bone 125cc service manual.pdf - Mojo

A.C GENERATOR / STARTER CLUTCH
STARTER COMP
SAI TUBE
A.C GENERATOR INSTALLTION
● Install the stator to the RH. Crankcase cover.
● Clean the tapered portion of the crankshaft.
● Clean the inside part of the flywheel.
● Check the woodruff key, install the flywheel by
aligning the groove with the woodruff key.
● Temporarily install the flywheel nut, hold the flywheel
with the universal holder, or remove the LH. crankcase
cover and tighten the flywheel nut with the specified
torque.
TORQUE VALVE : 5.0~6.0kgf m
TOOL : UNIVERSAL HOLDER
● Hold the drive face with drive face holder and install
the cooling fan.
● Install the LH. crankcase cover.
TORQUE : 0.8~1.2kgf
m
● Install the RH. Shroud.
● Connect the A.C.G wiring coupler and connector to the
wire harness, and install the wiring with the clamp.
● Install rear under cover.
● Install the muffler.
COOLING FAN
SAI REED VALVE
SAI PIPE
RH. CRANK CASE COVER
RH. CRANKCASE COVER
● Remove the following parts.
- Rear under cover.
- Ex. Muffler.
- Rear swing arm.
- RH shroud.
- Cooling fan.
- A.C.G starter comp.
- SAI reed valve.
● Loosen the flange bolt securing the RH. Crankcase
cover.
● Remove the RH crankcase cover.
9-4