Daelim B-Bone 125cc service manual.pdf - Mojo

STARTER SYSTEM
BRUSH HOLDER SET
STARTER MOTOR ASSEMBLY
● Install the brush and brush spring to the brush hold set.
● Insert the brush terminal into the rear bracket, and
install the terminal set and flange nut.
● Align the brush holder set with the rear bracket
groove, and install the brush holder set.
● Apply grease to both ends of the armature shaft, and
install the 2 washers.
● Push and hold the brush inside the rear bracket, and
insert the armature into the rear bracket groove.
RR. BRACKET
● Align the yoke with the rear bracket mark, and install
the yoke to the amature.
RR. BRACKET
△! CAUTION
●The sliding surfaces of the brushes can be damaged if
they are not installed properly.
●When inserting the armature into the case, hold the
armature tightly to keep the magnet from pulling the
armature against the case.
● Align the front bracket with the yoke mark, and install
the front bracket.
● Tighten the 2 set bolts.
MARK
FR. BRACKET
YOKE
RR. BRACKET
△!
CAUTION
●When installing the cover, take care to prevent
damaging the oil seal lip with the shaft.
●Overtightening the starter motor cable terminal nuts
may cause the inside the starter motor, resulting in
serious damage to the inner connectors.
SETTING BOLT
18-5