Daelim B-Bone 125cc service manual.pdf - Mojo

BRAKE SYSTEM
BREEDER VALVE
BREEDER HOSE
● Fill the brake fluid up to the upper limit line.
●Connect the transparent bleeder hose to the bleeder
valve and place the other end of the hose in a container.
1 Squeeze the brake lever, then open the bleeder
valve 1/2 turn, and close the valve.
△! NOTE
●Do not release the brake lever until the bleeder valve
has been closed.
FR. BRAKE LEVER
2 Release the brake lever slowly and wait several
seconds after it reaches the end of its travel.
3 Repeat the above steps 1 and 2 until bubbles
cease to appear in the fluid at the end of the hose.
● Check the fluid level often, and add fluid if the fluid
level is near the lower level.
● If no air leaks out of the bleeder hose, operate the brake
lever to check the presence of air.
● Tighten the bleeder valve.
TORQUE VALUE : 0.4~0.7 kgf·m
DIAPHRAGM PLATE
● Be sure that the brake fluid is up to the upper level of
the master cylinder and refill if necessary
● Reinstall the diaphragm, diaphragm plate and oil cup
cap.
TORQUE VALUE : 1.0 kgf·m
RR. BRAKE BREEDER VALVE
REAR CALIPER
REAR BRAKE BLEEDLING (INTERLOCK)
● The rear brake is apply to interlocking system, when
squeezing the right side brake lever, the front and rear
brake works at once.
1 Fill the brake fluid up to the upper limit line.
2 Connect the breeder hose to the breeder valve on
the rear caliper and bleed air.
BREEDER HOSE
15-4