Daelim B-Bone 125cc service manual.pdf - Mojo

BRAKE SYSTEM
AIR GUN
DISASSEMBLY
● Remove the rear brake caliper.
● Check the caliper assembly.
● Remove the pad spring, slide pin, caliper bracket and
boot from the caliper body.
● If there is any wear or damage in the boot, replace it
with a new one.
PISTON
DUST SEAL
● Wrap the caliper with a piece cloth to avoid piston and
brake fluid leakage and facing the piston downward.
● Remove the piston from the caliper, while blowing the
low-pressure air in the opening of the brake hose.
△! CAUTION
●Never use the high-pressure air or bring the air gun too
close.
●Never touch the inside of the caliper.
CALIPER BODY
● Disassemble the piston seal and the dust seal.
● Clean the piston and inside of the caliper with the brake
fluid.
PISTON
INSPECTION
● Check the caliper cylinder bore for scoring scratches or
other damage.
● Measure the caliper cylinder I.D
CYLINDER I.D.B : 25.07mm
● Check the caliper piston outer diameter part for
scratches or other damage.
● Measure the piston outer diameter .
SERVICE LIMIT : 24.8mm
15-9