Daelim B-Bone 125cc service manual.pdf - Mojo

EMS(Engine Management System)
4) Check if crank signal A,B wires is breaks or not.
Remove the ECU, connect wire harness for inspection to wire harness of vehicle.
Check the wiring of crank signal A
- Measure terminal : No. 30 pin of wire harness for inspection - Red wire of coupler of CKP.
- Measuring resistance : 0 ~ 1[]
Red
CKP_B CKP_A
1 2
Check the wiring of crank signal B
- Measure terminal : No. 22 pin of wire harness for inspection - Blue wire of coupler of CKP.
- Measuring resistance : 0 ~ 1[]
CKP_B CKP_A
1 2
Blue
5) After fault repaired, to erase the memorized fault code in the ECU is refer to how to remove the fault code(5-10)
5-38