Daelim B-Bone 125cc service manual.pdf - Mojo

A.C GENERATOR / STARTER CLUTCH
FLYWHEEL
DRIVE FACE
● Install the universal holder on the flywheel.
● If the universal holder connot be used, remove the LH.
crankcase cover at the left side of the crankshaft, and
hold the drive face with the drive face holer.
A.C.G ROTOR PULLER
A.C.G COUPLER
● Loosen the flange nut securing the fly wheel, and
remove the flywheel using the A.C.G rotor puller.
△!
CAUTION
●Insert the puller shaft and remove the flywheel
after inserting the A.C.G rotor puller and
securing it with spanner.
●The flywheel may easily removed if you rotate
the puller while tapping the puller shaft with
metal hammer.
●Always use a holder and a puller to remove the
flywheel. Do not try to remove the flywheel by
hammering directly on it. The crankshaft or
components could be damaged.
●After removing the flywheel, check the
woodruff key for damage and wear.
STARTER COMP
● Disconnect the A.C.G wire coupler.
TOOL : A.C.G ROTOR PULLER
UNIVERSAL HOLDER
DRIVE FACE HOLDER
● Loosen the fan screw securing the starter comp and
remove the starter comp on the RH.crankcase cover.
RH. CRANK CASE COVER
9-3