Installation Manual

Chapter 4
2. Select Name and enter the name to be associated with the selected key, then press OK.
The desired name is associated with the key.
3. Select Number and enter the telephone number to be associated with the key, then press
OK.
The desired number is associated with the key.
4. Press Exit to go back to the home page.
Relocating and retaining IP Touch sets
This section describes how to relocate and retain the same set.
In the procedure below, it is assumed that:
- there is one DHCP server
- no VLAN has to be configured.
Prerequisites
None.
Relocating and retaining the same set
To relocate and retain the same set:
1. Unplug the set.
2. Plug the set into a connector at its new location.
Rebooting the set
As of R9.0, to reboot a set:
1. In OMC, go to Users/Base stations List > Details.
2. Click Reset button.
The Reset window opens.
3. Select Reboot and click OK.
4. In the confirmation window, click Yes.
4.6 9 Series Sets
4.6.1 4019 Digital Phone
4.6.1.1 Commissioning
4.6.1.1.1 Overview
This module presents all the actions required for commissioning the Alcatel-Lucent 4019
Digital Phone set.
The following figure illustrates the connectors on the base of the set.
4-70