Installation Manual

Chapter 4
The Video Support feature right is specific to each 8082 My IC Phone set. Video telephony is
enabled or disabled specifically for each set.
Note:
Enabling is mandatory to support Video calls (incoming or outgoing) for 8082 My IC Phone sets.
To enable/disable “Video Support”
OMC -> User/Base stations List -> 8082 MY IC Phone-> Details-> Features -> Feature
Rights -> Part 1
Video support: select the check box to allow video support on the 8082 My IC Phone.
4.4.2.1.4 SIP door phone parameters
Note 1:
If SIP door phone management is to be done with video support, refer to Video Call parameters to enable
video.
The generic parameters for SIP door phone management with 8082 My IC Phone can be
modified at
OMC -> Subscribers Misc -> Generic Parameters for SIP Phones -> Door Phone
Parameters
OMC Parameter
Common/Specific
to 8082 My IC
phones
Default Value
Door Phone Name Common Doorcam STRING
Door Open Signal Common 55 STRING
Possible Values
Door Phone Name: defines the name that must be given for all SIP door phone terminals.
Default value for this parameter is 'Doorcam'.
The unique name defined with ‘Door Phone Name’ parameter is used by 8082 My IC Phone to
identify calls from SIP door phones.
Note 2:
The 'Door Phone Name’ parameter is case sensitive. SIP door phone names must be unique and not the
same as the ‘Door Phone Name’ parameter.
Door Open Signal: defines the DTMF code that is sent from 8082 My IC Phone to SIP door
phone to open the door latch. The default value for this parameter is 55.
4.4.2.1.5 Upgrading the software
The Alcatel-Lucent OmniTouch 8082 My IC Phone set software is upgraded during
OmniPCX Office software upgrade. Ensure the 8082 My IC Phone option is validated in the
OMC-Software Download window: refer to System Startup from OMC - Downloading the
Software
4.4.3 4135 IP Conference Phone
4.4.3.1 Commissioning
4.4.3.1.1 Overview
4-48