Installation Manual
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
For performance and safety reasons, the whole system must always be coupled<br />
to the ground. The ground must be connected before any other connections.<br />
The ground protection connection terminal must always be connected to the<br />
ground. Protective grounding terminal shall be permanently connected to the ground.<br />
4.3.1.5.2 OmniPCX Office RCE Compact<br />
OmniPCX Office RCE Compact platform is powered by an external power supply unit<br />
(100/240V). It is connected via a jack plug at the front of the module (right hand side).<br />
Remarks:<br />
- A mains cable is not supplied with the module. It must be ordered separately.<br />
- For a more secure configuration, an AC/DC power supply, including a backup battery, can be<br />
purchased as an optional extra.<br />
Permanent Ground<br />
4.3.1.6 Power Up<br />
It is essential to connect the system permanently to ground due to leakage currents greater<br />
than 3.5 mA over the whole line access (safety constraint CEI60950 ed.03).<br />
To do this, use the ground wire of minimum section 2.5 mm 2 (not supplied) and connect it to<br />
the tag on the metal bottom of the unit (right hand side).<br />
For performance and safety reasons, the system must always be connected to the<br />
ground. The ground must be connected prior to all the other connections.<br />
For performance and safety reasons, the whole system must always be coupled<br />
to the ground. The ground must be connected before any other connections.<br />
The ground protection connection terminal must always be connected to the<br />
ground. Protective grounding terminal shall be permanently connected to the ground.<br />
Having made all the connections, it is now time to power up the system.<br />
- Insert the mains cable in the socket on the rear of the unit.<br />
- Press the ON/OFF button. The system will reinitialize (duration: 3 to 4 minutes).<br />
To stop the system:<br />
- Press the ON/OFF button, the RED LED will flash.<br />
- Wait until the LED stops flashing and is lit steadily (between 15 seconds and 3 minutes<br />
depending on the configuration): the system is switched off.<br />
4.3.1.6.1 Power Up of Dedicated Terminals<br />
On powering up, dedicated sets execute a self-test:<br />
- Display Test<br />
- Test of the LEDs or icons on the terminal and add-on module, if any<br />
4-33
Change language