Installation Manual

More documents

Recommendations

Info

_dne-egnahc_ _nigeb-egnahc_ _dne-egnahc_ Chapter 6 The screen displays a default end IP address (192.168.092.039). Only the DHCP1 IP address range includes default IP addresses. The following softkey is available: - Clear: Clear the EndIP@ field Other fixed keys of the set: - Back: Return to the previous menu (DHCP1) - Exit: Return to home page - Left and right keys of the 4-way navigator: moving cursor in text - OK: Validation of the Start IP address field - Backspace: Deletion of one or more characters 6.1.1.4.2 Configuration of the OmniPCX Office DHCP server for Alcatel-Lucent OmniSwitch The following softkeys are available: - StartIP: See StartIP - Disable or Enable: Disabling or enabling OmniPCX Office DHCP server for omniswitch (enabled by default) - EndIP: See EndIP Other fixed keys of the set: - Back: Return to the previous menu ( IP configuration ) 6-6
_nigeb-egnahc_ _dne-egnahc_ _nigeb-egnahc_ _dne-egnahc_ - Exit: Return to home page StartIP The screen displays a default start IP address (192.168.092.005) The following softkey is available: - Clear: Clear the StartIP@ field Other fixed keys of the set: - Back: Return to the previous menu ( Configuration of the OmniPCX Office DHCP server for Alcatel-Lucent OmniSwitch ) - Exit: Return to home page - Left and right keys of the 4-way navigator: moving cursor in text - OK: Validation of the Start IP address field - Backspace: Deletion of one or more characters EndIP The screen displays a default end IP address (192.168.092.009) The following softkey is available: - Clear: Clear the EndIP@ field Other fixed keys of the set: - Back: Return to the previous menu ( Configuration of the OmniPCX Office DHCP server 6-7
Page 1 and 2:
Installation Manual Release 9.1 - J
Page 3 and 4:
Chapter 1 General Presentation Pre
Page 5 and 6:
Managed services ..................
Page 7 and 8:
System Startup from a Phone Set ...
Page 9 and 10:
_nigeb-egnahc_ _dne-egnahc_ 1.1
Page 11 and 12:
the system as well as any external
Page 13 and 14:
Figure 1.5: OmniPCX Office RCE Comp
Page 15 and 16:
2.1 Overview Alcatel-Lucent OmniPCX
Page 17 and 18:
Figure 2.2: Mini-MIX connections on
Page 19 and 20:
2.3 Installation 2.3.1 Overview
Page 21 and 22:
Board Function Optional boards Conn
Page 23 and 24:
Board used for connecting up digita
Page 25 and 26:
T2 Name T1 Name Function BUSY BUSY
Page 27 and 28:
2.4.2.11 DDI-X Board This board is
Page 29 and 30:
Boards Slots 1-2 CPU Slot PowerCPU
Page 31 and 32:
3.1 Software Licence Management 3.1
Page 33 and 34:
- Stations in the default Attendant
Page 35 and 36:
Controlled services Relevant softwa
Page 37 and 38:
Controlled services Number of activ
Page 39 and 40:
Controlled services TAPI 2.1 SERVER
Page 41 and 42:
egistration is accepted but the set
Page 43 and 44:
2 access on CPU III main, 16 access
Page 45 and 46:
3.4.16.2 Call accounting over IP Th
Page 47 and 48:
This license item is a global param
Page 49 and 50:
4.1 Presentation 4.1.1 Location of
Page 51 and 52:
4.1.2 Environment 4.1.2.1 Climatic
Page 53 and 54:
- 1 to 16: connecting analog Z term
Page 55 and 56:
4.2.1.4 Connecting Terminals 4.2.1.
Page 57 and 58:
4.2.1.5 Connection to the Public Ne
Page 59 and 60:
4.2.1.5.2 Digital Public Network by
Page 61 and 62:
4.2.1.5.4 Analog Public Network - D
Page 63 and 64:
Audio Input Characteristics: Input
Page 65 and 66:
4.2.1.7.6 Connecting a Doorphone 2
Page 67 and 68:
4.2.1.7.7 Using the 12V Output The
Page 69 and 70:
delivered with inter-battery connec
Page 71 and 72:
lack) and that there is no cable co
Page 73 and 74:
1. Ensure that the ON/OFF switch on
Page 75 and 76:
1. Stop the Alcatel-Lucent OmniPCX
Page 77 and 78:
2. Insert the batteries in the open
Page 79 and 80:
Note: If a hard disk is installed o
Page 81 and 82:
For performance and safety reasons,
Page 83 and 84:
Connecting the set This section des
Page 85 and 86:
The DHCP offer provides the followi
Page 87 and 88:
Displayed Status Set not connected
Page 89 and 90:
2. Connect the set, refer to Connec
Page 91 and 92:
- Proprietary Dynamic: the set acce
Page 93 and 94:
5. Select Loudspeaker 6. If your de
Page 95 and 96:
Country Type Brazil Costa-Rica Guat
Page 97 and 98:
This module presents all the action
Page 99 and 100:
For dynamic commissioning, operatio
Page 101 and 102:
- In the ALU IP Phones: DHCP IP Ran
Page 103 and 104:
Set unregistered SIP registration O
Page 105 and 106:
- Subnet mask (if no DHCP server is
Page 107 and 108:
Figure 4.44: Alcatel-Lucent IP Touc
Page 109 and 110:
You do not use a DHCP server Static
Page 111 and 112:
In the procedure below, it is assum
Page 113 and 114:
- Connect an IP Touch set to the LA
Page 115 and 116:
Static 1. Connect the power supply.
Page 117 and 118:
The 3.5 mm female jack can receive
Page 119 and 120:
Figure 4.46: Alcatel-Lucent 4019 Di
Page 121 and 122:
- Connect optional equipment - Prog
Page 123 and 124:
- F1/F2 keys - Add-On Module keys (
Page 125 and 126:
4.7.1.2.2 ECM 4.7.1.2.3 V24 & CTI -
Page 127 and 128:
The V24/CTI Interface Module is con
Page 129 and 130:
4.8.1.1 Overview The AP Interface M
Page 131 and 132:
4.8.2.2 Jumper The jumper in a gray
Page 133 and 134:
6 Not used Analog device socket: Pi
Page 135 and 136:
4.9.1.2.3 ISDN - EN55022: Limits an
Page 137 and 138:
The S0 module is connected to: Figu
Page 139 and 140:
8 Not used Power supply socket: Pin
Page 141 and 142:
Take as an example a building with
Page 143 and 144:
Figure 4.67: ARI Number Note 1: The
Page 145 and 146:
Once the IBS finishes the downloadi
Page 147 and 148: 2 1926.875 3 1925.625 4 1924.375 5
Page 149 and 150: Square zone Rectangular zone Exampl
Page 151 and 152: Important: An IP-DECT system cannot
Page 153 and 154: 4.12.2 Additional Information 4.12.
Page 155 and 156: then pull it out). - Plug in the li
Page 157 and 158: List of abbreviations - TD: Transmi
Page 159 and 160: 4.14 Extending Your Installation 4.
Page 161 and 162: Permanent replacement The default c
Page 163 and 164: - 0,5 mm cable: 505 m - 0.6 mm cabl
Page 165 and 166: RJ45 pin 1 2 3 4 5 6 7 8 MAIN: TX+
Page 167 and 168: emove CoCPUs). 3. Use LOLA to save
Page 169 and 170: 4.15.1.3.3 Hardware 4.15.1.4 Licens
Page 171 and 172: If successfully connected, a list o
Page 173 and 174: To check if the versions of Exchang
Page 175 and 176: 4.15.1.7.5 Dialing Rules My IC Soci
Page 177 and 178: 4.16 ACD applications 4.16.1 Platfo
Page 179 and 180: 5.1 Detailed description 5.1.1 Defa
Page 181 and 182: Figure 5.2: Virtual Key Functions f
Page 183 and 184: Figure 5.4: Virtual and Physical Ad
Page 185 and 186: Figure 5.6: [US only] Virtual Key F
Page 187 and 188: Figure 5.8: Virtual Key Functions f
Page 189 and 190: Figure 5.10: [US only] Virtual Key
Page 191 and 192: There are 10 pages of virtual keys
Page 193 and 194: 6.1 System Startup from a Phone Set
Page 195 and 196: _dne-egnahc_ _nigeb-egnahc_ This s
Page 197: _dne-egnahc_ _nigeb-egnahc_ _dne-eg
Page 201 and 202: The direct number includes up to 8
Page 203 and 204: This function is used to indicate t
Page 205 and 206: This is used to make secure data tr
Page 207 and 208: 6.2.1 Overview OMC is the PC applic
Page 209 and 210: The default IP address for the main
Page 211 and 212: ISDN 64 to 128 KPBS modems handling
Page 213 and 214: Follow the procedures described in
Page 215 and 216: - Enter the New Password - Confirm
Page 217 and 218: Remark: If you select immediate swi
Page 219 and 220: - Call groups - Broadcast groups -
Page 221 and 222: - An Installation Wizard to help in
Page 223 and 224: 7.1 Maintenance Level 1 7.1.1 Maint
Page 225 and 226: from your body. When holding a boar
Page 227 and 228: 7.1.1.6.2 Storage - Always wear a d
Page 229 and 230: 8.1 A ACD Automatic Call Distributi
Page 231 and 232: 8.4 D DAP DECT Access Point DASS2 D
Page 233 and 234: Internet Protocol Security. Standar
Page 235 and 236: POP3 Post Office Protocol. Standard
Page 237 and 238: TERMINAL GROUP Series of terminals
show all

Installation Manual

Create successful ePaper yourself

Delete template?

Save as template?