Installation Manual
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Chapter 4 <br />
- Audio test<br />
If this sequence is correct, the display on the dedicated terminals shows the system date:<br />
Monday 01 January 00h00.<br />
After powering up, you can activate the system from a dedicated terminal or by OMC (refer to<br />
the specific notice).<br />
4.4 SIP Terminals<br />
4.4.1 8002/8012 Desk Phone<br />
4.4.1.1 Commissioning<br />
4.4.1.1.1 Overview<br />
This module presents all the actions required for commissioning the 8002/8012 Deskphone<br />
sets.<br />
4.4.1.1.2 Commissioning the set<br />
This section describes how to commission the set in the two available initialization options:<br />
- Static initialization: commissioning is manual on the set and through OMC<br />
- Dynamic initialization (DHCP): no commissioning is needed, 8002/8012 Deskphone sets<br />
are fully plug & phone<br />
Depending on the selected mode, the set commissioning is different.<br />
For static initialization, the operation order is as follows:<br />
1. Connect the set, refer to Connecting the set<br />
2. Configure network parameters on the set, refer to Commissioning the Set in Static Mode<br />
For dynamic initialization, the operation order is as follows:<br />
1. Configure OmniPCX Office DHCP server, refer to Configuring OmniPCX Office DHCP<br />
server , or configure an external DHCP server, refer to Configuring an external DHCP<br />
server for dynamic initialization<br />
2. Connect the set, refer to Connecting the set<br />
3. If necessary, configure the user name and password in OMC, refer to Configuring the user<br />
name and password in OMC<br />
Prerequisites<br />
- The Alcatel-Lucent OmniPCX Office Communication Server version must be R9.0 or<br />
higher and the system must be operational<br />
- For network configuration, any of the following must be implemented:<br />
• In dynamic mode, a DHCP server must be configured<br />
• In static mode, a free IP address must be available for the set<br />
- A port with PoE must be available on a switch. If not available, a PoE injector or a specific<br />
Power Adapter must be used<br />
4-34