Installation Manual
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Chapter 4 <br />
- Initialize the 8082 My IC Phone set<br />
Selecting the initialization type<br />
The default initialization is dynamic Alcatel-Lucent Enterprise.<br />
To select the initialization type, refer to the following table.<br />
If<br />
You use OmniPCX<br />
Office DHCP server<br />
You use another DH-<br />
CP server<br />
You do not use a DH-<br />
CP server<br />
table 4.18: Initialization type selection<br />
Then the required initialization<br />
type<br />
Further information<br />
is<br />
Dynamic or Proprietary<br />
Dynamic<br />
- Refer to Configuring OmniPCX Office<br />
DHCP server<br />
Dynamic - Refer to Configuring an external DHCP<br />
server for dynamic initialization<br />
Static - Refer to Configuring network parameters<br />
for static initialization<br />
- Obtain from your network administrator:<br />
• An IP address for the 8082 My IC<br />
Phone set<br />
• The subnetwork mask<br />
• The router address<br />
• The DNS addresses (primary and<br />
secondary)<br />
• The VLAN ID (if VLAN is used)<br />
• The IP address of the Alcatel-Lucent<br />
OmniPCX Office Communication<br />
Server for set configuration file<br />
download<br />
Configuring OmniPCX Office DHCP server<br />
Note:<br />
You need to know the set directory number.<br />
As of R9.1, the OmniPCX Office DHCP server is enabled by default during startup wizard<br />
installation. If enabled, 8082 My IC Phone sets automatically initialize in dynamic mode, when<br />
plugged to the OmniPCX Office. In other words, 8082 My IC Phone sets automatically get their<br />
IP configuration from the OmniPCX Office DHCP server<br />
If the OmniPCX Office DHCP server is disabled, you can enable it as follows:<br />
- In OMC, go to Hardware and Limits > LAN/IP Configuration > DNS/DHCP.<br />
- In the ALU IP Phones: DHCP IP Range area, select the Enable check box.<br />
- Modify the range of IP addresses if needed.<br />
- Click the OK button to confirm your entries.<br />
Configuring an external DHCP server for dynamic initialization<br />
Two types of dynamic initialization are available:<br />
- Dynamic (default value): the set selects in priority DHCP offers, with a Vendor Specific<br />
option corresponding to an Alcatel-Lucent server.<br />
4-42