MIC1462 manual.pdf
MIC1462 manual.pdf
MIC1462 manual.pdf
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
6c Band Alarm 2 BaAlarm2 If Alarm 2 is a ±(Input Span)<br />
Value<br />
Band Alarm, the From setpoint<br />
band of process Default = five<br />
variable values input units<br />
outside (centered on<br />
which the pro- the setpoint)<br />
cess variable will<br />
cause the alarm<br />
to be active<br />
6d Deviation DeAlarm 2 If Alarm 2 is a ±(input range)<br />
(High/Low) Deviation High/ from setpoint.<br />
Alarm 2 Value Low alarm, Default = five<br />
gives a value input range<br />
above (positive units<br />
value) or below<br />
(negative value)<br />
the setpoint. If<br />
the process<br />
variable deviates<br />
from the setpoint<br />
by a margin<br />
greater than this<br />
value, the alarm<br />
becomes active<br />
7 Alarm 2 Al2 Hyst A non-zero 1 unit to X units<br />
Hysteresis valuedefines a where X = 10%<br />
value<br />
hysteresis band of input span.<br />
on the safe side<br />
of the Alarm 2<br />
value<br />
8 Loop Alarm Loop Alm Enables/dis- EnAb<br />
Enable ables Loop disA<br />
Alarm<br />
Default=disA<br />
MIC 1462 Manual 52<br />
Edition 1
Change language