MIC1462 manual.pdf

7.4 EDITING/VIEWING PARAMETERS IN ANY/EACH
SEGMENT IN A SPECIFIC PROFILE
(Program Number = 1 to 8, Segment Number = 1-16)
Adjust the Program Number (using the PROF key) and the Segment Number
(using the RUN/HOLD key) as required. The parameters presented will
be these relevant to the program and segment whose numbers are displayed.
The parameters sequence for each segment is as follows:
To view parameters in the Segment catagory, press the PROF key until the
desired Program Number is displayed. Press the RUN/HOLD key until the
desired Segment Number is displayed.
MESSAGE
AVAILABLE
STEP DESCRIPTION DISPLAY FUNCTION SETTING
1 Final Setpoint Value Final SP Defines the Numeric value
final value of (limited by
the setpoint SPHi and
for this SPLo) or
segment, (by pressing
selects a the UP/
dwell segment DOWN keys
or indicates simultanea
Join, Repeat, ously)
or End Program indicates a
segment dwell with:
_ _ _ _
or, if the
segment is
already a
Join, Repeat,
or End
Program
segment,
as shown
below
MIC 1462 Manual 66
Edition 1