MIC1462 manual.pdf
MIC1462 manual.pdf
MIC1462 manual.pdf
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Now, with Program 2 set to perform 10 cycles, change its last segment to a<br />
Repeat segment (Segment Time or Ramp Rate set to REP); the result<br />
would be:<br />
PROGRAM 1<br />
PROGRAM 1<br />
PROGRAM 2<br />
1<br />
2<br />
3<br />
4 5<br />
1<br />
2<br />
3<br />
4 5<br />
1<br />
2<br />
3<br />
Join<br />
Segment<br />
Repeat<br />
Segment<br />
10 Cycles<br />
At the end of the tenth cycle of Program 2, the program sequence would<br />
end.<br />
7.6 BASIC RULES TO REMEMBER<br />
In any program sequence:<br />
• A program ending in a Join segment will perform the required number<br />
of cycles of itself before joining the new program.<br />
• A program ending in a Repeat segment (hence, by definition, the last<br />
program in the sequence) will perform the required number of cycles of<br />
itself before ending the sequence.<br />
• A program ending in an End segment (hence, by definition, the last<br />
program in the sequence) will perform its cycle on the entire program<br />
sequence before ending that sequence.<br />
7.7 EXITING PROFILE SET MODE<br />
The operator may exit from Profile Set Mode by pressing the MODE key,<br />
then pressing the SCROLL key, which will cause a return to the Base<br />
Mode.<br />
Edition 1<br />
71 MIC 1462 Manual