Agilent 33120A User's Guide

Chapter 3 Features and FunctionsPower-On and Reset StatePower-On and Reset StateThe parameters marked with a bullet ( œ ) are stored in non-volatile memory.The factory settings are shown.NOTE: The power-onstate will be differentif you have enabledthe power-downrecall mode.See “Power-Down RecallMode” on page 109for more information.Output ConfigurationFunctionFrequencyAmplitude (into 50 ohms)OffsetOutput UnitsOutput TerminationModulationAM Carrier WaveformAM Modulating WaveformAM DepthFM Carrier WaveformFM Modulating WaveformFM Peak Frequency DeviationBurst Carrier FrequencyBurst CountBurst RateBurst Starting PhaseFSK Carrier WaveformFSK “Hop” FrequencyFSK RateModulation StateSweep Start / Stop FrequencySweep TimeSweep ModePower-On/Reset StateSine wave1 kHz100 mV peak-to-peak0.00 VdcVolts peak-to-peak50 ohmsPower-On/Reset State1 kHz Sine wave100 Hz Sine wave100%1 kHz Sine wave10 Hz Sine wave100 Hz1 kHz Sine wave1 cycle100 Hz0 degrees1 kHz Sine wave100 Hz Sine wave10 HzOff100 Hz / 1 kHz1 secondLinearFor your convenience,this table is duplicatedon the rear cover of thismanual and on theQuick Reference Card.3System-Related Operationsœ Power-Down RecallDisplay Modeœ Comma SeparatorsPower-On/Reset Stateœ DisabledOnœ OnTriggering OperationsTrigger SourcePower-On/Reset StateInternalInput/Output Configurationœ GPIB Addressœ Interfaceœ Baud Rateœ ParityPower-On/Reset Stateœ 10œ GPIB (IEEE-488)œ 9600 baudœ None (8 data bits)CalibrationCalibration StatePower-On/Reset StateSecured123