Agilent 33120A User's Guide

Chapter 5 Error MessagesCalibration ErrorsCalibration ErrorsThe following errors indicate failures that may occur during acalibration. Refer to the Service Guide for more information.701 Cal security disabled by jumperThe calibration security feature has been disabled with a jumper insidethe function generator. When applicable, this error will occur atpower-on to warn you that the function generator is unsecured.702 Cal securedThe function generator is secured against calibration.703 Invalid secure codeAn invalid calibration security code was received when attempting tounsecure or secure the function generator. You must use the samesecurity code to unsecure the function generator as was used to secure it,and vice versa. The security code may contain up to 12 alphanumericcharacters. The first character must be a letter.704 Secure code too longA security code was received which contained more than 12 characters.705 Cal abortedA calibration in progress is aborted when you press any front-panel key,send a device clear, or change the local/remote state of the instrument.706 Cal value out of rangeThe specified calibration value (CAL:VALUE) is invalid for the presentlyselected function.707 Cal signal measurement out of rangeThe specified calibration value (CAL:VALUE) does not match the signalapplied to the function generator.708 Flatness cal failed709 Cannot calibrate frequency while externally lockedYou cannot perform CAL:SETUP 0 or CAL:SETUP 86 while the functiongenerator is externally phase locked (Option 001).760 RAM checksum failure238